Reversing Stainless Steel Glass Doors

Remove preexisting bottom hinge.

1.Remove the preexisting bottom hinge (three screws) (2).

1.Install the hinge just removed from the bottom to the TOP opposite side of the cabinet (three screws) (2).

1.Install plastic screw plugs (three each, top and bottom) (3) into holes where hinge hardware was removed.

1.Remove plastic hole plug from top of door handle and reinstall on opposite side.

2.With bottom of door facing up, remove pivot plate (5) (two screws).

3.Flip over and install pivot plate on opposite side of door. Ensure notch in plate faces center.

1.Hold door upright and tilted forward.

2.Lift door on to bottom hinge closer inserts.

3.Tilt door forward into position.

4.Hold door to keep it from falling.

5.Reinstall hinge screw pin (1) into top hinge using a Phillips screwdriver.

Align and adjust the door:

Align and adjust the door, see DOOR ALIGNMENT AND ADJUSTMENT on page 7.

3 1

1.Hold door to keep it from falling.

2.Remove hinge screw pin (1) from top hinge using a Phillips screwdriver.

3.Remove door by tilting forward and lifting door off bottom hinge closer inserts.

4.Reinstall hinge screw pin (1) into top hinge using a Phillips screwdriver.

1.Remove plastic screw plugs from (three each, top and bottom)

(3) from new hinge location. Save for reinstallation later.

Remove Stainless Frame

1.Remove two screws from top of door. Save screws for later installation.

2.Remove pivot plate from bottom of door by removing 2 screws. Set pivot plate and screws aside for later installation.

u-line.com