| DOOR FRAME |
| TAPE |
TOP OF | BOTTOM OF |
OVERLAY | |
| OVERLAY |
| ULIN_0418_A |
6.Use the door frame holes as a guide to drill pilot holes for the #6x1" pan head screws.
#6 x 1" Pan Head | Screws |
|
|
| |||||
|
| (10Total) |
| Top Of Panel | Tape | ||||
| |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Assembling Door to Cabinet
8.Starting at the corners and working toward the center, push the door gasket back into place. Make sure the gasket is fully seated on all four sides and corners.
9.Check the closure assembly on the bottom hinge to be sure it is seated correctly in the bosses in the hinge.
Door closers
Depending on installation bottom of overlay may NOT align with bottom of door
7. Attach the door to the overlay using #6x1" wood screws.
NOTICE
If you decide to drill pilot holes, remove the wood overlay from the door, and do not use a drill larger than 7/64". Be sure not to drill deeper than 3/8". The door frame and wood overlay must be aligned properly or the door will not operate correctly.
Note: After attaching the wood to the door, double check the bottom pivot hole location. If the hole in the pivot bracket is covered by any wood, chase through the hole with a 11/32" drill to open hole in door panel. DO NOT drill deeper than 1/4".
10.Position door over closer. Be sure the door hinge plate holes align with the bosses on the closer (see below). Failure to do so will result in the door not sitting in the proper position and door will not align correctly. (Sometimes it is helpful to open the door 180° to have the closer and pivot align correctly.)
11.Holding the door in the closed position, install the pivot post through the top hinge into the top pivot plate. Tighten securely with a Phillips screwdriver, making sure post is seated fully.
12.Adjusting the door as needed.
19 |