CLR2060 — Clear Ice Maker | ™ |
| |
|
|
Back of | Tape | |
Removed | ||
Wood | ||
Door Panel | ||
Panel | ||
| ||
Side of |
| |
Wood Panel | Bottom of | |
| Wood Panel | |
5/16" | 3/8" | |
Bottom | Both Sides | |
Figure 20 |
|
Typical | Door Panel |
Wood Panel |
|
Top
Pivot Plate
#10 x 5/8"
Round Head Screw
Six Required
Plastic Spacer
Six Required
Figure 22
5.Remove the existing bottom pivot plate and replace with the Full Overlay pivot plate (see Figure 23).
1"± 1/32" 
Figure 21
Rear View
of
Wood Panel
1"± 1/32" 
Drill 5/32" x 3/8" Deep for use with #10 x 5/8" Wood Screw and Nylon Spacer – 6 Places
27"± 1/4"
14-5/16"± 1/4"
1"± 1/8"
Existing |
|
Door | Wood Panel Bottom Pivot Plate |
| (5/8" Longer Than |
Existing Bottom Pivot Plate | Existing Bottom Pivot Plate, |
(Remove and Discard) | Flush Side Facing Out) |
| |
| Two Places |
Figure 23
IMPORTANT
Door panel and overlay panel must be aligned properly or the door will not operate correctly.
Assembling the Door
1.Install the assembled panel by sliding the original door panel back into the doorframe.
2.Replace the
3.Starting at the corners and working toward the center, push the door gasket back into place.
4.Attach the door panel to the overlay panel using #10 x 5/8" wood screws and nylon spacers. The nylon spacers fit between the overlay panel and the door panel as shown in Figure 22. The spacers allow the original door panel to slide back into the
Installing the Door
1.Remove the existing hinges from the unit, saving the door closure assembly.
2.Install the new Replacement Top Hinge onto the unit (see Figure 24).
10 | 02/2005 |