CLR2060 — Clear Ice Maker | ™ |
| |
|
|
Installation Troubleshooting
Q: Problem
Water is leaking under the unit.
A: Solution
A water leak under the unit is most likely caused by a bad connection in the water supply line. Make sure the water line’s brass fitting is screwed tight to its valve and threaded correctly. Make sure the fill tube’s connection to the water line is also tight. Check drain line to make sure it has not been disconnected from drain connection on back of the unit or disconnected from the drain.
Q: Problem
The door remains open unless it is pushed closed.
A: Solution
The hinges should be
Q: Problem
The custom overlay door was designed to align with the rest of the cabinet doors, but the unit has crept forward.
A: Solution
First, make sure that the electrical cord and water supply line are not obstructing the installation. If they are not, there is mostly likely not enough room allowed for the drain connection on the rear of the unit. You may need to alter the wall behind the unit to accommodate the drain connection.
10 Start-Up for the First Time
Initial Start-Up
Once installation and leveling is complete, the unit is ready for initial
I C E |
O F F |
C L N |
I C E |
O F F |
C L N |
Cycle Selector |
Switch |
Figure 45 |
1.Open the door and remove the cover in front of the evaporator by gently compressing and pulling forward. This will enable you to observe the water flow over the evaporator.
2.Check that the overflow tube is inserted securely into the water trough.
3.Put the cycle selector switch (in the grille) in the ICE position (press the switch up). The water fill valve will energize and fill the water reservoir. The water fill valve shuts off after approximately 180 seconds (3 minutes). The compressor begins to operate.
18 | 02/2005 |