™ | CLR2060 — Clear Ice Maker |
|
4.Watch the water flow over the evaporator assembly (ice cube tray) to familiarize yourself with the operation. Upon initial
5.Replace the evaporator cover.
IMPORTANT
It is possible that dirt or scale will dislodge in the water line. Always throw away all ice cubes made during the first two to three hours of operation.
Start-Up Troubleshooting
Q: Problem
Unit does not appear to turn on when switch is set to ICE.
A: Solution
Remember that the compressor will not operate until the water has been filling for about 3 minutes. Make sure unit is plugged in and outlet has power (circuit breaker has not tripped). If the unit is equipped with a drain pump, check that the drain line is not obstructed — unit will shut down due to the safety design of the pump if water cannot drain.
About Settings
All settings are factory preset. No adjustments should be necessary at this time. For information about Ice Cube Thickness, see the User Manual.
Q: Problem
Water does not appear to be flowing into unit.
A: Solution
Check that the water is connected and turned on, the line is not obstructed and the overflow tube is inserted securely into water trough.
Q: Problem
The unit has been operating for 24 hours and water is still not flowing evenly over evaporator or ice seems slow to release.
A: Solution
Level unit for even water flow. Uneven water flow will reduce ice rate and cause water to spill in ice bin.
IMPORTANT
See the User Manual’s Troubleshooting Guide for more solutions.
02/2005 | 19 |