Factory-Installed Drain Pump

™	CLR2060 — Clear Ice Maker

Gravity Drain
	Waste
	Shut-Off
	Valve
	Cold
Hot	Water
Water
Waste
Figure 31

If using a Gravity Drain:

1.Attach the 5/8-inch ID drain connection on the back of the unit to a 5/8-inch OD rigid tube, using a worm clamp.

2.Attach the other end of the rigid tube to your 5/8-inch ID drain line with a worm clamp.

3.Insulate the drain line, if necessary to prevent condensation. Go on to Water Supply Connection.

If your drain line will run up to a stand pipe, disposal assembly or spigot assembly or does not otherwise meet the requirements for a Gravity Drain, you may have ordered the CLR2060 with a U-Line P60 Drain Pump. See Figures 32, 33 and 34 for typical installations requiring a Drain Pump. If you need to install a P60 Drain Pump into your unit, see Locally-Installed Drain Pump on Page 14.

Stand Pipe
	Waste
	Shut-Off
	Valve
	Cold
Hot	Water
Water
Waste
Figure 32

Disposal Assembly
Air Gap
(Optional Hook-Up)
	Waste
	Cold
Hot	Water
Water
	Shut-Off
	Valve
Figure 33

Spigot Assembly
Air Gap
(Optional Hook-Up)
	Waste
	Shut-Off
	Valve
	Cold
Hot	Water
Water
Figure 34

IMPORTANT

Before installing your U-Line CLR2060 with Factory- Installed U-Line P60 Pump, it is extremely important to check and test all hose connections at the drain pump. There is a possibility that hose connections may have loosened during shipment.

WARNING

To prevent accidental electrocution, make certain that the floor surfaces surrounding the unit are dry whenever power is removed from, or applied to, the unit.

02/2005