Water Supply Connection

™	CLR2060 — Clear Ice Maker

CAUTION

In the event of a power outage, restricted drain or pump failure, the failure to use the U-Line P60 drain pump or a

3.Carefully bend the water supply line into position and connect the line to the solenoid valve (see Figure 39). Avoid kinking the water supply line.

pump with the above listed specifications, could result in substantial water leakage and pooling with severe and costly water damage and related consequential damages and harm.

When connecting the water supply, follow these guidelines:

• Review the local plumbing codes before you install the
	unit.
• Connect to the cold water supply.
•	The water pressure should be between 20 and 120 psi.
•	Install a shut-off valve in the 1/4 inch OD water supply

Water Line	Power
Water Line	Cord
Figure 39

Figure 40

line.

• Connect sufficient tubing to the unit so that tubing

may be looped, allowing the unit to be removed for

cleaning and servicing (see Figure 40). However, make

certain that the tubing is not pinched or damaged

during installation.

• U-Line recommends the use of copper tubing for

installation.

To connect to water supply:

1.Install the 1/4 inch OD copper water line from the main water source (see Figure 37).

IMPORTANT

Normal operation creates some vibration. A water supply line contacting cabinet wall may cause excessive noise during operation or damage to the line.

4.For recessed installations, allow extra water supply line length to provide slack for easy removal from the recessed area (see Figure 40). This will also safeguard against kinking the line.

5.Go on to 7 Prepare Power Supply

Water

Connection

Figure 37

Figure 38

2.Locate the compression fitting and ferrule packed with this guide. Slide the compression fitting and ferrule over the 1/4-inch OD water supply line. Do not use thread sealing compound or tape. Using two wrenches, tighten the compression fitting on the supply line (see Figure 38).

02/2005