™ | CLR2060 — Clear Ice Maker |
|
4 Prepare and Install Door Panel
(Black and White Units Only)
Two types of custom door panels can be installed on your Black or White unit to harmonize with or accent the surrounding décor: a Custom 1/4" Insert or a Full Overlay. If no custom door panel is used, go on to 5 Adjust Door.
Custom 1/4'' Door Panel Insert
Door Panel Preparation
A custom door panel can be inserted into the doorframe. Custom door panels can be flat or raised, as long as the maximum panel thickness where inserted into the door
Figure 12 |
Figure 13 |
reveal (channel) is
IMPORTANT
Raised panels will reduce the door’s 90° swing/zero clearance if the unit is installed next to a wall or similar type of structure (see Page 4).
Cut the panel insert to the following dimensions.
Custom 1/4" Dimensions:
Width:
Height:
The door panel must not weigh more than 20 lbs.
Door Panel Installation
Install the insert as follows:
CAUTION
Use care when handling the insert. Insert edges may be sharp.
1.Remove top hinge screw pin (7/64" Allen wrench or Phillips screwdriver, depending on your unit’s construction, see Figure 12). Remove door by tilting forward and lifting off bottom hinge pin.
2.Pull door gasket out of groove (top edge of door only). Start in the middle and pull outward, moving toward the edge (see Figure 13). This may take some force. Do not remove the three screws behind gasket.
3.Remove two outside screws holding door handle. Slightly separate door handle from door (see Figure 14).
4.Pull handle up and off.
5.Remove and discard existing panel.
6. Slide custom door panel insert into
7.Holding door gasket out of the way, replace handle
on door, making sure it is Figure 14 seated properly on insert
and that screw holes line up.
8.Install two small screws removed in Step 3.
9.Starting at the corners and working inward, push door gasket into place on door.
10.Place door on bottom hinge pin and install upper hinge screw. Go on to 5 Adjust Door.
02/2005 | 7 |