Full Overlay Door Panel

CLR2060 — Clear Ice Maker	™
CLR2060 — Clear Ice Maker

Door Panel Preparation

A full overlay door panel completely covers the doorframe and handle to give a built-in appearance. See your U-Line dealer for the optional Full Overlay Door Panel Kit (P/N U-OL2015B — Black or P/N U-OL2015W — White). Appropriate hardware, Modified Handle, Replacement Hinges and a copy of these instructions will be included in the kit.

13/32"

0.177" Dia. (#16 Drill)

13/32"

11/16" Deep

3/8"

13/16"

Door Bottom:

5/16" Dia. x 1/4" Deep

Chamfer 1/32" x 45°

Top View

Bottom View

1.Cut the overlay to the following dimensions (see Figure 15).

Full Overlay Dimensions:

Width: 14-3/4"

Height: 29-7/8"

The door panel must not weigh more than 20 lbs.

3/4"

1/8"

13/16"

1-17/32"

7/16"

5/16" Dia.

x 1/2" Deep

13/32"	1/8"		1/8"

1/32" R

1/8" R

13/16"

3/4"

13/16"
	1/8"
1/8"
Relief Notch	Rear View	29-7/8"
Relief Notch	of
for Pivot Plate	of
for Pivot Plate	Wood Panel
	Wood Panel

14-3/4"

Figure 15

IMPORTANT

Rear View of wood panel for right-hand hinge shown. Use mirror image for left-hand hinges.

2.Create a relief (Figure 15) for pivot plate by cutting notch in top corner and coinciding back corner of overlay panel. Refer to Figure 16 for exact specifications.

Back View

Side View

Figure 16

Route notch in top corner of overlay panel as shown (see Top and Side Views). Top of notch is entire depth of panel, front to back.

Width: 13/16"

Depth: 1/8"

Route notch in backside of top corner of overlay panel (see Back and Side Views).

Width: 13/16"

Depth: 1/8"

Height: 1-17/32" from top edge of panel (less 1/8" for depth of notch on top of panel)

Radius of corner notch: 1/8" (see Back View)

3.Drill holes for pivot plate mounts (see Figure 16, Back View).

5/16" diameter x 1/2" deep, from the routed surface

CAUTION

Be careful not to drill too deep! Drilling holes too deep may destroy your door panel.

www.U-LineService.com

02/2005