Smeg STA6248, STA6249 instruction manual User instructions, Adjusting The Upper Basket

Page 26

ADJUSTING THE UPPER BASKET

User instructions

ADJUSTING THE UPPER BASKET

The height of the top basket can be adjusted to allow large dishes or pans to be placed in the bottom basket.

The adjustment procedure may be type A, B or C, depending on the dishwasher model purchased.

Version A: pull-out with adjustment in two positions on the right hand side.

•Pull out the right-hand basket guide.

•Remove the stop, first releasing it as shown in the diagram.

•Push the guide to free the wheels.

•Fit the upper or lower pair of wheels into the guide, depending on the setting required.

•Return the stop to its original position.

Version B: push-button with adjustment in two positions on the right hand side.

•Pull out the basket to its limit position and pull the right side upwards. At this point it is possible to load larger sized plates into the lower basket.

•To return to the original position, pull out the upper basket again and press the release lever.

25

Image 26

Contents GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAMS Contents USES OTHER THAN THOSE DESCRIBED ABOVE Safety instructions1. Safety and operating instructions NEVER BE REMOVEDTHIS DISHWASHER MUST BE USED BY ADULTS AQUASTOP MODELS APPLIANCE2.1 Water supply connection Installation instructions2. Installation and hook-up CONNECTING TO THE WATER SUPPLY DRAIN CONNECTIONIF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD 2.2 Electrical connection and precautionsNEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD Fuse replacement FOR GREAT BRITAIN ONLYSELECTED PROGRAM INDICATOR LIGHTS User instructions3. Description of the controls 3.1 Upper panelDELAYED START LIGHTS on some models only SETTING THE WASHING PROGRAM AND SWITCHING ONDELAYED START BUTTON on some models only Only run the soak program with half loads The correct amount of detergent has been added to the dispenser 3.2 Washing programsBefore starting a washing program make sure that TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT CANCELLING THE CURRENT PROGRAMCHANGING THE PROGRAM TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENTEND OF CYCLE REMOVING THE DISHES4. Operating instructions 4.1 Using the water softening systemADJUSTING THE WATER SOFTENING SYSTEM 4.2 Using the rinse aid and detergent dispensers WATER HARDNESS TABLEADJUSTING THE RINSE AID DISPENSER SETTING ADDING THE RINSE AIDADDING THE DETERGENT During the washing cycle, the dispenser will be opened automaticallyCorrect loading of the dishes helps ensure optimal washing results 4.3 General warnings and recommendations3/1 Products Dishes and objects in copper, tin, zinc or brass these tend to stain LOADING THE LOWER BASKET 4.4 Using the basketsLOWER BASKET CUTLERY BASKET UPPER BASKET LOADING THE UPPER BASKETADJUSTING THE UPPER BASKET Version C with adjustment in three positions on both sides CLEANING THE SPRAY ARMS 5. Cleaning and maintenanceCLEANING THE WATER INTAKE FILTER 5.1 General warnings and recommendationsPROLONGED DISUSE CLEANING THE FILTER UNITGENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCE Fill the rinse aid dispenser Shut off the water supply tapBEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE TROUBLESHOOTING MINOR PROBLEMSIf the dishes are not being cleaned properly, check that Reconnect the water intake hose and open the tap againIf there are visible traces of rust inside the tank If the dishes fail to dry or remain dull, check thatIf the dishes show signs of streaking, staining, etc., check that Safety level 6. TroubleshootingFAULT E1 E2 E3 E4 E5 E6Alternate washing system malfunction E7 E8 E9Turbine flow-regulator malfunction Water intake system malfunctionWidth TECHNICAL DATAElectrical characteristics Height depending on models Capacity Water supply pressure