Smeg STA6249 User instructions, Version C with adjustment in three positions on both sides

Page 27

Version C: with adjustment in three positions on both sides.

User instructions

Version C: with adjustment in three positions on both sides.

The sides of the basket must always be set at the same height. This adjustment is only available on some “maxi” model dishwashers (at least 860 mm tall).

•Raise the basket by pulling on the top edge (1), to the first or second catch depending on the height required.

•To lower the basket, first release it by pulling the release lever (2).

Adjustment is also possible with the basket loaded, but in this case when lowering the basket it should be held steady with one hand to avoid knocking the dishes.

26

Image 27

Contents GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAMS Contents NEVER BE REMOVED Safety instructions1. Safety and operating instructions USES OTHER THAN THOSE DESCRIBED ABOVETHIS DISHWASHER MUST BE USED BY ADULTS APPLIANCE AQUASTOP MODELSInstallation instructions 2. Installation and hook-up2.1 Water supply connection DRAIN CONNECTION CONNECTING TO THE WATER SUPPLY2.2 Electrical connection and precautions NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEADIF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD FOR GREAT BRITAIN ONLY Fuse replacement3.1 Upper panel User instructions3. Description of the controls SELECTED PROGRAM INDICATOR LIGHTSSETTING THE WASHING PROGRAM AND SWITCHING ON DELAYED START BUTTON on some models onlyDELAYED START LIGHTS on some models only Only run the soak program with half loads 3.2 Washing programs Before starting a washing program make sure thatThe correct amount of detergent has been added to the dispenser TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT CANCELLING THE CURRENT PROGRAMCHANGING THE PROGRAM TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENTREMOVING THE DISHES END OF CYCLE4.1 Using the water softening system 4. Operating instructionsADJUSTING THE WATER SOFTENING SYSTEM WATER HARDNESS TABLE 4.2 Using the rinse aid and detergent dispensersADDING THE RINSE AID ADJUSTING THE RINSE AID DISPENSER SETTINGDuring the washing cycle, the dispenser will be opened automatically ADDING THE DETERGENT4.3 General warnings and recommendations 3/1 ProductsCorrect loading of the dishes helps ensure optimal washing results Dishes and objects in copper, tin, zinc or brass these tend to stain 4.4 Using the baskets LOWER BASKETLOADING THE LOWER BASKET CUTLERY BASKET LOADING THE UPPER BASKET UPPER BASKETADJUSTING THE UPPER BASKET Version C with adjustment in three positions on both sides 5.1 General warnings and recommendations 5. Cleaning and maintenanceCLEANING THE WATER INTAKE FILTER CLEANING THE SPRAY ARMSFill the rinse aid dispenser Shut off the water supply tap CLEANING THE FILTER UNITGENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCE PROLONGED DISUSEReconnect the water intake hose and open the tap again TROUBLESHOOTING MINOR PROBLEMSIf the dishes are not being cleaned properly, check that BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSEIf the dishes fail to dry or remain dull, check that If the dishes show signs of streaking, staining, etc., check thatIf there are visible traces of rust inside the tank E1 E2 E3 E4 E5 E6 6. TroubleshootingFAULT Safety levelWater intake system malfunction E7 E8 E9Turbine flow-regulator malfunction Alternate washing system malfunctionHeight depending on models Capacity Water supply pressure TECHNICAL DATAElectrical characteristics Width