Smeg ST1144S instruction manual Safety instructions, Safety and operating instructions

Page 16

Safety instructions

1. Safety and operating instructions

THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL.

INSTALLATION MUST BE PERFORMED BY A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USE, AND COMPLIES WITH THE EEC DIRECTIVES 72/23, 89/336 (INCLUDING 92/31) CURRENTLY IN FORCE, INCLUDING THE PREVENTION AND ELIMINATION OF RADIO FREQUENCY INTERFERENCE.

THE APPLIANCE IS DESIGNED FOR THE FOLLOWING PURPOSE: WASHING AND DRYING OF DISHES; ANY OTHER USE SHALL BE CONSIDERED IMPROPER. THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR

USES OTHER THAN THOSE DESCRIBED ABOVE.

THE NAME PLATE FEATURING THE TECHNICAL DATA, SERIAL NUMBER AND MARKINGS IS VISIBLY POSITIONED ON THE INNER EDGE OF THE DOOR. THE NAME PLATE ON THE INNER EDGE OF THE DOOR MUST

NEVER BE REMOVED.

DO NOT LEAVE THE DISCARDED PACKAGING MATERIALS UNSUPERVISED WITHIN THE HOME. SEPARATE THE VARIOUS MATERIALS WHICH MAKE UP THE PACKAGING AND TAKE THEM TO THE NEAREST SORTED WASTE COLLECTION CENTRE.

THE APPLIANCE MUST BE PROVIDED WITH AN EARTH CONNECTION IN ACCORDANCE WITH THE ELECTRICAL SAFETY REGULATIONS IN FORCE.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR DAMAGE TO PERSONS OR PROPERTY RESULTING FROM THE FAILURE TO EARTH THE APPLIANCE OR FROM A DEFECTIVE EARTH CONNECTION.

THE POWER SUPPLY LEAD PLUG AND THE RELATIVE SOCKET MUST BE OF THE SAME TYPE AND COMPLY WITH THE RELEVANT REGULATIONS. CHECK THAT THE MAINS VOLTAGE AND FREQUENCY ARE THE SAME AS THE VALUES MARKED ON THE NAMEPLATE. DO NOT USE ADAPTERS OR SHUNTS. NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER

SUPPLY LEAD.

•AFTER INSTALLATION, THE PLUG MUST REMAIN ACCESSIBLE.

•IN THE EVENT OF DAMAGE TO THE POWER CORD, HAVE IT REPLACED BY A QUALIFIED TECHNICIAN.



Page 15 Page 17
Image 16
Page 15 Page 17
Contents Guide for Using the Dishwasher and the Washing Programs Contents Description of the controls Upper panelSetting the Washing Program and Switching on Program Delay Button on some models only140 Cancelling the Current Program Table for Certification BodiesReference standard Changing the ProgramWashing programs Selecting Half Load Wash on some models onlyDelaying the Program Extra ProgramsElectronic Setting models with display Adjusting the Water Softening SystemWater Hardness Table Switch Setting models without display END of Cycle Removing the DishesTroubleshooting Fault DescriptionWater intake system malfunction For Cleaning Dishwashers Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation and hook-up Water supply connectionElectrical connection Connecting to the Water SupplyDrain Connection Using the water softening system Operating instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent 1 Products General warnings and recommendations User instructions Using the baskets EN 50242 Standard Loads for Certification BodiesEN 50242 cycle test conditions Lower BasketLoading the Lower Basket Cutlery Basket Upper Basket Loading the Upper BasketAdjusting the Upper Basket Push-button versionCleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsCleaning the Filter Unit Prolonged DisuseBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598
Top Page Image Contents