Smeg ST1144S Adjusting the Water Softening System, Electronic Setting models with display

Page 9

User instructions

ADJUSTING THE WATER SOFTENING SYSTEM

Depending on model, the setting may be made electronically or by means of a selector switch.

ELECTRONIC SETTING (models with display)

N.B.: for the setting below to be possible, a washing program other than the soak program must be set.

Press the PROGRAM DELAY button (10) and keep it pressed until the preset value appears followed by a full stop (normally 3.).

Release the button then press it again in succession to display the value required, referring to the table.

The 6 setting levels available will appear in this order: 3., 4., 5., 0., 1., 2..

When the value required appears on the display, release the button; after 5 seconds the system automatically returns to setting of the program delay, and the setting will be made with the chosen value.

N.B.: the display shows the water hardness setting and the program delay. The dot (.) after the number indicates that the water hardness setting is being displayed. If the dot (.) does not appear, the program delay is being displayed.

WATER HARDNESS TABLE

	WATER HARDNESS					SETTING

German Degrees (°dH)			French Degrees (°dF)

0	- 5		0	- 9		0.

6 - 11			10	- 19		1.

12	- 21		20	- 36		2.

22	- 33		37	- 59		3.

34	- 45		60	- 79		4.

46	- 53		80 - 107			5.

Contact your local water board for information on the hardness of your water supply.

Image 9

Contents Guide for Using the Dishwasher and the Washing Programs Contents Upper panel Description of the controlsProgram Delay Button on some models only Setting the Washing Program and Switching on140 Table for Certification Bodies Cancelling the Current ProgramReference standard Changing the ProgramSelecting Half Load Wash on some models only Washing programsExtra Programs Delaying the ProgramAdjusting the Water Softening System Electronic Setting models with displayWater Hardness Table Switch Setting models without display Removing the Dishes END of CycleFault Description TroubleshootingWater intake system malfunction For Cleaning Dishwashers Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models Water supply connection Installation and hook-upConnecting to the Water Supply Electrical connectionDrain Connection Operating instructions Using the water softening systemUsing the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent 1 Products General warnings and recommendations User instructions EN 50242 Standard Loads for Certification Bodies Using the basketsEN 50242 cycle test conditions Lower BasketLoading the Lower Basket Cutlery Basket Loading the Upper Basket Upper BasketPush-button version Adjusting the Upper BasketCleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsProlonged Disuse Cleaning the Filter UnitBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598