Smeg ST1144S instruction manual Before Starting the Dishwasher After Prolonged Disuse

Page 35

User instructions

BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE:

•Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the water to run from the water supply tap for a few minutes.

•Plug the power cord back into the socket.

•Reconnect the water intake hose and open the tap again.

TROUBLESHOOTING MINOR PROBLEMS

In some cases it is possible to remedy minor problems by referring to the following instructions:

If the program fails to start, check that:

•the dishwasher is connected to the electrical power supply;

•there is no power failure;

•the water tap is open;

•the dishwasher door is properly closed.

If water remains inside the dishwasher, check that:

•the drain hose is not kinked;

•the drain siphon is not obstructed;

•the dishwasher filters are not clogged.

If the dishes are not being cleaned properly, check that:

•the correct amount of detergent has been added;

•there is regenerating salt inside the special container;

•the dishes are being loaded correctly;

•the selected program is suitable for the dish types and their degree of soiling;

•all the filters are clean and positioned correctly;

•the spray arm nozzles are not obstructed;

•there is no object obstructing the rotation of the spray arms.

Image 35

Contents Guide for Using the Dishwasher and the Washing Programs Contents Upper panel Description of the controlsProgram Delay Button on some models only Setting the Washing Program and Switching on140 Changing the Program Cancelling the Current ProgramTable for Certification Bodies Reference standardSelecting Half Load Wash on some models only Washing programsExtra Programs Delaying the ProgramWater Hardness Table Adjusting the Water Softening SystemElectronic Setting models with display Switch Setting models without display Removing the Dishes END of CycleFault Description TroubleshootingWater intake system malfunction For Cleaning Dishwashers Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models Water supply connection Installation and hook-upDrain Connection Connecting to the Water SupplyElectrical connection Operating instructions Using the water softening systemUsing the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent 1 Products General warnings and recommendations User instructions Lower Basket Using the basketsEN 50242 Standard Loads for Certification Bodies EN 50242 cycle test conditionsLoading the Lower Basket Cutlery Basket Loading the Upper Basket Upper BasketPush-button version Adjusting the Upper BasketAvoid the use of acidic or abrasive detergents Cleaning and maintenanceCleaning the Water Intake Filter Cleaning the Spray ArmsProlonged Disuse Cleaning the Filter UnitBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598