Fluke PM6681R Error Code 1150 to, Reset during bus, Some PC controller cards has been known to do

Error Messages

CNT-8X Device specific errors (leading 1 only for PM6681)

Error	Error Description	description/explanation/examples
Number
(1)150	Bad math expres-	Only a fixed, specific math expression is recognized
	sion format	by the counter, and this was not it.
(1)160	Measurement bro-	A new bus command caused a running measure-
	ken off	ment to be broken off.
(1)170	Instrument set to	An internal setting inconsistency caused the instru-
	default	ment to go to default setting.
(1)190	Error during calibra-	An error has occurred during calibration of the in-
	tion	strument.
(1)191	Hysteresis calibra-	The input hysteresis values found by the calibration
	tion failed	routine was out of range. Did you remember to re-
		move the input signal?
(1)200	Message exchange	An error occurred in the message exchange handler
	error	(generic error).
(1)201	Reset during bus in-	The instrument was waiting for more bus input, but
	put	the waiting was broken by the operator.
(1)202	Reset during bus	The instrument was waiting for more bus output to be
	output	read, but the waiting was broken by the operator.
(1)203	Bad message ex-	An internal error in the message exchange handler.
	change control state
(1)204	Unexpected reason	A spurious GPIB interrupt occurred, not conforming
	for GPIB interrupt	to any valid reason like an incoming byte, address
		change, etc.
(1)205	No listener on bus	This error is generated when the counter is an ac-
	when trying to re-	tive talker, and tries to send a byte on the bus, but
	spond	there are no active listeners.
		(This may occur if the controller issues the device
		talker address before its own listener address, which
		some PC controller cards has been known to do)
(1)210	Mnemonic table er-	An abnormal condition occurred in connection with
	ror	the mnemonics tables (generic error).
(1)211	Wrong macro table	The macro definitions have been corrupted (could
	checksum found	be loss of memory).
(1)212	Wrong hash table	The hash table has been corrupted. Could be bad
	checksum found	memory chips or address logic. Contact your local
		service center.
(1)213	RAM failure to hold	The memory did not retain information written to it.
	information (hash	Could be bad memory chips or address logic. Con-
	table)	tact your local service center.

8-14 Error Code (1)150 to -(1)213