Smeg ST1144S instruction manual If the dishes fail to dry or remain dull, check that

Page 36

User instructions

If the dishes fail to dry or remain dull, check that:

•there is rinse aid inside the special container;

•the rinse aid dispenser setting is correct;

•the detergent used is of good quality and has not lost its effectiveness (for example, through incorrect storage, with the box left open).

If the dishes show signs of streaking, staining, etc., check that:

•the rinse aid dispenser setting is not too high.

If there are visible traces of rust inside the tank:

•the tank is made of steel, and therefore any rust marks are due to external elements (fragments of rust from the water pipes, pots, cutlery, etc.). Special products are commercially available t o remove such marks;

•check that the amount of detergent being used is correct. Certain detergents can be more corrosive than others.

•check that the cap of the salt container is securely closed, and that the water softening setting is correct.

If after following the above troubleshooting instructions the problem persists, call the nearest After-Sales Centre.

WARNING: any operations performed on the appliance by unauthorised persons are not covered by the warranty and shall be paid for by the user.

TECHNICAL DATA

 

 

 

 

 

Width

597 ⎟ 599 mm

 

 

 

Depth measured flush with the

 

Free standing: 600 mm

outer edge of the control panel

 

Semi-integrated: 590 mm - Fully integrated: 570 mm

 

 

 

Height (depending on models)

 

Free standing: from 850 mm to 870 mm

 

 

from 890 mm to 910 mm

 

 

Semi-integrated and fully integrated: from 820 mm to 870 mm

 

 

from 860 mm to 910 mm

 

 

 

Capacity

 

14 Standard place settings

 

 

 

Water supply pressure

 

min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar)

 

 

 

Electrical characteristics

 

See rating plate



Page 35 Page 37
Image 36
Page 35 Page 37
Contents Guide for Using the Dishwasher and the Washing Programs Contents Description of the controls Upper panelSetting the Washing Program and Switching on Program Delay Button on some models only140 Cancelling the Current Program Table for Certification BodiesReference standard Changing the ProgramWashing programs Selecting Half Load Wash on some models onlyDelaying the Program Extra ProgramsAdjusting the Water Softening System Electronic Setting models with displayWater Hardness Table Switch Setting models without display END of Cycle Removing the DishesTroubleshooting Fault DescriptionWater intake system malfunction For Cleaning Dishwashers Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation and hook-up Water supply connectionConnecting to the Water Supply Electrical connectionDrain Connection Using the water softening system Operating instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent 1 Products General warnings and recommendations User instructions Using the baskets EN 50242 Standard Loads for Certification BodiesEN 50242 cycle test conditions Lower BasketLoading the Lower Basket Cutlery Basket Upper Basket Loading the Upper BasketAdjusting the Upper Basket Push-button versionCleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsCleaning the Filter Unit Prolonged DisuseBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598
Top Page Image Contents