Smeg ST1144S instruction manual Setting the Washing Program and Switching on

Page 4

8

User instructions

HALF LOAD BUTTON (on some models only)

Press this button to activate the half load wash option.

HALF LOAD LIGHT (on some models only)

9One of the two buttons illuminates to indicate that the half load wash option in the top or bottom basket has been selected.

10PROGRAM DELAY BUTTON (on some models only)

Press this button to delay the start of the program by up to 9 hours.

11INFORMATION DISPLAY (on some models only)

SETTING THE WASHING PROGRAM AND SWITCHING ON

To select the most suitable program for the dishes to be washed refer to the table below, which indicates the most appropriate program according to dish type and degree of soiling.

After using the table to identify the most appropriate washing program:

•press the ON/OFF button (1) and wait for the PROGRAM INDICATOR LIGHT (2) to illuminate;

•keep pressing the PROGRAM SELECTION button (3) until the indicator light corresponding to the desired program illuminates;

•close the door; after about 2" the program will start. While it is in progress, the relative LIGHT will flash (indicating that the program is being executed).

Image 4

Contents Guide for Using the Dishwasher and the Washing Programs Contents Description of the controls Upper panelSetting the Washing Program and Switching on Program Delay Button on some models only140 Cancelling the Current Program Table for Certification BodiesReference standard Changing the ProgramWashing programs Selecting Half Load Wash on some models onlyDelaying the Program Extra ProgramsElectronic Setting models with display Adjusting the Water Softening SystemWater Hardness Table Switch Setting models without display END of Cycle Removing the DishesTroubleshooting Fault DescriptionWater intake system malfunction For Cleaning Dishwashers Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation and hook-up Water supply connectionElectrical connection Connecting to the Water SupplyDrain Connection Using the water softening system Operating instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent 1 Products General warnings and recommendations User instructions Using the baskets EN 50242 Standard Loads for Certification BodiesEN 50242 cycle test conditions Lower BasketLoading the Lower Basket Cutlery Basket Upper Basket Loading the Upper BasketAdjusting the Upper Basket Push-button versionCleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsCleaning the Filter Unit Prolonged DisuseBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598