Smeg ST1144S instruction manual Water intake system malfunction

Page 13

User instructions

E7

E8

E9



FAULT

DESCRIPTION

 

 

 

Turbine flow-regulator malfunction

 

(for the relevant models only)

 

The appliance is not able to "measure" the amount of

 

water loaded accurately. Interrupt the program and

 

switch off the dishwasher. Switch the dishwasher

 

back on, program it again and start the washing

 

cycle. If the problem persists, contact the after-sales

 

service.

Alternate washing system malfunction

Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and start the washing cycle. If the problem persists, contact the after-sales service.

Water intake system malfunction

Contact the after-sales service.

Light off

Light on

Light flashing

If an alarm occurs the appliance interrupts the program in progress and signals a fault.

•Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program immediately.

•The E5, E6 alarms interrupts the running program once the cause is resolved, it will bring bach the execution of the program.

•The alarm E7 is visualized at the end of the cycle that comes, however, brought to the end since the operation of the dishwasher is not harmed.

To “reset” an alarm is necessary:

•Open and close the door, or turn off and on the machine. At this point is possible to program the dishwasher again.

If the malfunction persists, contact your authorised Service Centre.

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Guide for Using the Dishwasher and the Washing Programs Contents Upper panel Description of the controlsProgram Delay Button on some models only Setting the Washing Program and Switching on140 Table for Certification Bodies Cancelling the Current ProgramReference standard Changing the ProgramSelecting Half Load Wash on some models only Washing programsExtra Programs Delaying the ProgramElectronic Setting models with display Adjusting the Water Softening SystemWater Hardness Table Switch Setting models without display Removing the Dishes END of CycleFault Description TroubleshootingWater intake system malfunction For Cleaning Dishwashers Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models Water supply connection Installation and hook-upElectrical connection Connecting to the Water SupplyDrain Connection Operating instructions Using the water softening systemUsing the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent 1 Products General warnings and recommendations User instructions EN 50242 Standard Loads for Certification Bodies Using the basketsEN 50242 cycle test conditions Lower BasketLoading the Lower Basket Cutlery Basket Loading the Upper Basket Upper BasketPush-button version Adjusting the Upper BasketCleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsProlonged Disuse Cleaning the Filter UnitBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598
Top Page Image Contents