Smeg ST1144S instruction manual END of Cycle, Removing the Dishes

Page 11

User instructions

If the door has to be opened while washing is in progress, the program will be interrupted. The relative light will keep flashing and a beeper will signal that the cycle has not been completed. You must wait about 1 minute before closing the door to restart the program. When the door is closed the program will continue from where it was interrupted. This operation should only be carried out if strictly necessary, because it might cause problems in execution of the program.

END OF CYCLE

At the end of the washing cycle the dishwasher gives a short acustic signal and the program indicators nr 4 and 5 start blinking (the word "end" is displayed on the window).

To switch off the dishwasher, open the door and press the ON/OFF button (1).

REMOVING THE DISHES

At the end of the washing program, wait at least 20 minutes before removing the dishes, to allow them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in the lower basket, it is advisable to unload the lower basket first, and then the upper basket.



Image 11
Contents Guide for Using the Dishwasher and the Washing Programs Contents Upper panel Description of the controlsProgram Delay Button on some models only Setting the Washing Program and Switching on140 Changing the Program Cancelling the Current ProgramTable for Certification Bodies Reference standardSelecting Half Load Wash on some models only Washing programsExtra Programs Delaying the ProgramWater Hardness Table Adjusting the Water Softening SystemElectronic Setting models with display Switch Setting models without display Removing the Dishes END of CycleFault Description TroubleshootingWater intake system malfunction For Cleaning Dishwashers Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models Water supply connection Installation and hook-upDrain Connection Connecting to the Water SupplyElectrical connection Operating instructions Using the water softening systemUsing the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent 1 Products General warnings and recommendations User instructions Lower Basket Using the basketsEN 50242 Standard Loads for Certification Bodies EN 50242 cycle test conditionsLoading the Lower Basket Cutlery Basket Loading the Upper Basket Upper BasketPush-button version Adjusting the Upper BasketAvoid the use of acidic or abrasive detergents Cleaning and maintenanceCleaning the Water Intake Filter Cleaning the Spray ArmsProlonged Disuse Cleaning the Filter UnitBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598