Smeg CIR575X, CIR574X, CIR576X Instructions for the user, Using The Hob, Ignition of the burners

Page 14
Instructions for the user

Instructions for the user

7. USING THE HOB

Before turning on the burners, make sure that the burner rings, caps and grids have been fitted correctly.

In the wok burner, notch A must be aligned with pin B.

Grid C provided is intended for use with woks (Chinese pans).

Adapter D comes only with open grids models and is intended for use with small sized vessels.

7.1 Ignition of the burners

On some models raised indicators make for easier and clearer reading and use of the controls, each knob being connected to its corresponding burner by a rib. Setting corresponds to the elongated part of the knob or to the marking on it.

(Only where applicable)

Double-crown burners, controlled by two knobs, feature two ribs, a long one corresponding to the small inner burner and a short one to the outer burner.

Double-crown burners comprise an auxiliary and a rapid burner, controlled by two different knobs which permit to use both burners at the same time or to select one or the other as required.

The device is fit with electronic ignition. Simply press and simultaneously turn the knob counter-clockwise on any position between the high flame and the low flame symbol, until the burner is ignited. Concerning models with valves, push the knob for approximately 2 seconds in order to keep the flame burning and to activate the safety device. The burner might go off when the knob is released. In this case repeat the aforesaid operation keeping the knob pressed for more than 2 seconds.

Should the burners go off accidentally in the models with valves, a safety device will trip after approximately 20 seconds to block the gas outlet even if the tap is open.

16

Image 14
Contents Contents NEVER UNPLUG BY PULLING ON THE CABLE Introduction1. INSTRUCTIONS FOR SAFE AND PROPER USE NEVER ATTEMPT TO REPAIR THE APPLIANCETHE PLATE ON THE CASING MUST NOT BE REMOVED 2.1 Attachment to support structure Instructions for the installer2. POSITIONING OF THE HOB 30 CM 70 CM HOB HOB 2.2Clearance above and around domestic appliancesExtract from AS5601 REQUIREMENTS NOTES2.3 Room ventilation 2.4 Discharge of combustion products3. GAS CONNECTION 4. ELECTRICAL CONNECTION 5. ADAPTATION TO DIFFERENT TYPES OF GAS 5.1 Removing the hob5.2 Adjustment for LPG Burner6. FINAL OPERATIONS 5.3 Adjustment for natural gas6.1 Adjustment of minimum for natural gas Burners 6.2 Arrangement of burners on the hob6.3 Lubrication of gas taps 7.1 Ignition of the burners 7. USING THE HOBInstructions for the user Burner 7.2Practical advice for using the burners7.3Diameter of containers Ø min. and max. in cm7.4.1 Turning on electric elements 7.4.2 Using the electric elements7.4 Electric elements To use correctly remember to 8.2 Cleaning of the hob components 8. CLEANING AND MAINTENANCE8.1 Cleaning 8.1.1 Regular daily cleaning of the hob8.3 Preventive maintenance CAUSE 9. PROBLEMS AND CAUSESPROBLEM WHAT TO DO