Smeg CIR575X, CIR574X, CIR576X manual Introduction, Instructions For Safe And Proper Use

Page 2
Introduction

Introduction

1. INSTRUCTIONS FOR SAFE AND PROPER USE

THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE HOB.

INSTALLATION MUST BE CARRIED OUT BY AN AUTHORISED PERSON IN ACCORDANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USES AND CONFORMS TO CURRENT REGULATIONS IN FORCE. THE APPLIANCE HAS BEEN BUILT TO CARRY OUT THE FOLLOWING FUNCTIONS: COOKING AND HEATING-UP OF FOOD. ALL OTHER USES ARE CONSIDERED IMPROPER.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE.

DO NOT LEAVE THE PACKING IN THE HOME ENVIRONMENT. SEPARATE THE VARIOUS WASTE MATERIALS AND TAKE THEM TO THE NEAREST SPECIAL GARBAGE COLLECTION CENTRE.

IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE GROUNDED ACCORDING TO THE METHODS REQUIRED BY SAFETY RULES.

THE PLUG TO BE CONNECTED TO THE POWER CABLE AND THE SOCKET MUST BE THE SAME TYPE AND MUST CONFORM TO CURRENT REGULATIONS.

NEVER UNPLUG BY PULLING ON THE CABLE.

IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE HOB, FOLLOWING THE INSTRUCTIONS BELOW. SHOULD THE APPLIANCE NOT FUNCTION, DISCONNECT IT FROM THE SUPPLY AND CALL THE NEAREST TECHNICAL ASSISTANCE CENTRE.

NEVER ATTEMPT TO REPAIR THE APPLIANCE.

ALWAYS CHECK THAT THE CONTROL KNOBS ARE IN THE POSITION "ZERO" (OFF) WHEN YOU FINISH USING THE HOB.

4

Image 2
Contents Contents NEVER UNPLUG BY PULLING ON THE CABLE Introduction1. INSTRUCTIONS FOR SAFE AND PROPER USE NEVER ATTEMPT TO REPAIR THE APPLIANCETHE PLATE ON THE CASING MUST NOT BE REMOVED 2.1 Attachment to support structure Instructions for the installer2. POSITIONING OF THE HOB 30 CM 70 CM HOB HOB 2.2Clearance above and around domestic appliancesExtract from AS5601 REQUIREMENTS NOTES2.3 Room ventilation 2.4 Discharge of combustion products3. GAS CONNECTION 4. ELECTRICAL CONNECTION 5. ADAPTATION TO DIFFERENT TYPES OF GAS 5.1 Removing the hob5.2 Adjustment for LPG Burner6. FINAL OPERATIONS 5.3 Adjustment for natural gas6.1 Adjustment of minimum for natural gas Burners 6.2 Arrangement of burners on the hob6.3 Lubrication of gas taps 7.1 Ignition of the burners 7. USING THE HOBInstructions for the user Burner 7.2Practical advice for using the burners7.3Diameter of containers Ø min. and max. in cm7.4.1 Turning on electric elements 7.4.2 Using the electric elements7.4 Electric elements To use correctly remember to 8.2 Cleaning of the hob components 8. CLEANING AND MAINTENANCE8.1 Cleaning 8.1.1 Regular daily cleaning of the hob8.3 Preventive maintenance CAUSE 9. PROBLEMS AND CAUSESPROBLEM WHAT TO DO