Smeg CS19ID-5 manual Instructions for the Installer, Installing The Appliance

Page 4

Instructions for the Installer

2. INSTALLING THE APPLIANCE

This appliance has fire protection (type Y) and can be installed against walls higher than the work surface.

In compliance with Electromagnetic Compatibility regulations, the electromagnetic induction hob is classified in Group 2 and Class B (EN 55011)

2.1 Electrical connection

Check that the voltage and size of the power supply line are as specified on the nameplate inside the storage compartment. This nameplate must never be removed.

The appliance's power supply line must be fitted with an omnipolar breaking device with contact gap of at least 3 mm, located in an easily accessible position close to the appliance itself.

The appliance has a terminal board on its rear for the electrical connection (see diagram below). To access it, remove the back cover.

Image 4

Contents Index 1. PRECAUTIONS FOR SAFETY AND USE IntroductionNEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD NEVER ATTEMPT TO REPAIR THE APPLIANCE YOURSELFTHE NAMEPLATE MUST NEVER BE REMOVED NEVER USE THE HOB AS A WORK-TOPInstructions for the Installer 2. INSTALLING THE APPLIANCEF five-wire cable cable of 5 x 2.5 mm2 F four-wire cable cable of 4 x 4 mm2Operation at 380-415V3N~ use a H05RR Operation at 380-415V2N~ use a H05RRInstructions for the User 3. DESCRIPTION OF CONTROLSKEY TO SYMBOLS THERMOSTAT KNOBFUNCTION SELECTOR KNOB HOB CONTROL KNOBPower Function Heating accelerator3.2 Electronic Analogue Clock on some models only 3.2.1 Setting the timeLIST OF FUNCTIONS 3.2.2 Minute-Minder 3.2.3 Programming 3.2.4 DEMO Function 4.1.1 Operating Powers 4. HOB4.1 Cooking zones 4.1.2 Types of pans 4.1.4 Residual heat 4.1.3 Pan present device4.1.5 Locking-out the hob Trigger Operationtemperature 4.2 Holding Function 5. USING THE OVEN 5.1 Precautions and General Advice5.2 Oven light 5.3 Storage compartment6. ACCESSORIES AVAILABLE 7. COOKING ADVICE 7.1 Conventional cookingThe oven door must be closed during cooking operations FUNCTION SELECTOR THERMOSTAT SET AT 50 - 250C7.2 Hot air cooking 7.3 Grilling FUNCTION SELECTOR THERMOSTAT AT MAXIMUM SETTINGThe oven door must be closed while cooking is in progress 7.4 Hot air grilling FUNCTION SELECTOR THERMOSTAT FROM 50 C TO 250C7.5 Defrosting FUNCTION SELECTOR THERMOSTAT SET ONWARNING the supports B must be fitted as shown on the right It is normal for the thermostat light to switch on and off at regularThe oven door must be closed while cooking is in progress CONVENTIONAL COOKING GRILLINGPASTA MEATHOT-AIR COOKING SWEETS CONFECTIONERY8. CLEANING AND MAINTENANCE 8.1 Cleaning the ceramic hob8.2 Cleaning stainless steel 8.2.1 Routine daily cleaning8.3 Cleaning the oven without self-cleaning liners 8.3.1 Self-cleaning liners8.3.2 Using the self-cleaning liners 8.3.3 Maintenance of self-cleaning liners8.3.4 Removing the self-cleaning liners 8.4 Door glazing9.1 Changing the light bulb 9. EXTRAORDINARY MAINTENANCEUse only light bulbs approved for ovens T 300C 9.2 Removing the door 9.3 Oven door gasket