Smeg LS19-7 User instructions, E5 E6, Fault, DESCRIPTION The dishwasher fails to draw water

User instructions

FAULT

E5

E6

DESCRIPTION

The dishwasher fails to draw water.

Check that:

•the water supply tap is open;

•the filter in the water intake hose is not clogged;

•the water intake hose is not kinked or bent;

Turn the dishwasher off and then on again, then press the START/PAUSE button (3) again. If the problem is resolved the washing program will resume from where it was halted.

If the fault persists, call the authorised technical service centre.

The dishwasher fails to drain.

Check that:

•the flexible drain hose is not kinked or obstructed;

•the water drain pipe is not obstructed;

•the dishwasher filter is not clogged;

Turn the dishwasher off and then on again, and then press the START/PAUSE button (3) again. If the problem is resolved, the washing program will resume from where it was halted.

Otherwise, if the fault persists, call the authorised technical service centre.

In the event of error codes not included in this table, call the Technical Service Centre.

TECHNICAL DATA
Width	597 ⎟ 599 mm
Depth measured flush with the	Free standing: 600 mm
outer edge of the control panel	Semi-integrated: 570 mm
Height (depending on models)	Free standing: from 850 mm to 870 mm
	from 890 mm to 910 mm
	Semi-integrated: from 820 mm to 870 mm
	from 860 mm to 910 mm
Capacity	14 Standard place settings
Water supply pressure	min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar)
Electrical characteristics	See rating plate

36