Integrated Refrigeration | 46 |
|
|
Cabinetry Applications
DOOR PANEL HEIGHT
The height of the door panel can extend beyond the typical panel height, provided you do not exceed the panel weight limit. The illustration below shows how the panel may be extended and what you need to consider to finish the area behind the door panel.
IMPORTANT NOTE: The decorative valance used to finish the area behind the door panel must stay behind the front plane of the finished molding.
TOE KICK CLEARANCE
The toe kick clearance can vary with the height of the panel. You must keep a minimum space of 102 mm clear below the bottom edge of the panel for proper venting. In addition, any decorative base molding must be removable to clean the condenser and for service.
|
| 635 mm TO WALL |
| 38 |
|
| mm |
|
|
| DECORATIVE VALANCE |
3 mm |
| CANNOT EXTEND BEYOND |
| THE FRONT OF THE MOLDING | |
OVERALL | DOOR | DECORATIVE VALANCE |
HEIGHT | PANEL |
|
3 mm |
|
|
|
| REMOVABLE MOLDING |
MINIMUM | HINGE |
|
HEIGHT |
|
|
TYPICAL |
|
|
HEIGHT |
| INTEGRATED UNIT |
OF DOOR |
| (SIDE VIEW) |
PANEL |
|
|
UPPER VALANCE
TALL MODELS
| INTEGRATED UNIT |
| (SIDE VIEW) |
HEIGHT | KICKPLATE/GRILLE |
OF PANEL | CAN BE ADJUSTED |
| FORWARD |
| KICKPLATE/GRILLE |
| BASE MOLDING |
| MUST BE |
| REMOVABLE |
102 mm TO 229 mm | 635 mm TO WALL |
FROM FLOOR |
|
| 67 mm TO 102 mm |
KICKPLATE/GRILLE AREA
ALL INTEGRATED MODELS