Traulsen G-Series owner manual You are now in the Customer / Service Parameters

VII. MICROPROCESSOR CONTROL (continued)

VII. d - NOTES TO THE USER:

You only have 20-30 seconds between button pushes. If you take longer than 30 seconds, the controller will revert back to displaying the cabinet temperature.If you enter the wrong security code, the controller will revert back to displaying the cabinet temperature. You can exit the parameters at any time by waiting 20-30 seconds for the control to return to normal operation.

VII. e - ENTER THE CUSTOMER ACCESS:

This is required to set any of the control parameters.

Use the security code “0, A, 1”

and the following instructions:

Press the set button SET . The display will read

Customer/Service Access.

Press the set button SET .

The display will show three zeros with the left zero flashing

.

Press the set button SET .
The display will show three zeros with the center zero flashing			.
Press the down arrow key		to sequence through F, E, d, C, b, A, 9, 8, 7,…etc.
When you reach “A” press set		SET .
The display will show “zero, A, zero” with the right zero flashing				.
Press the up arrow key	to sequence through 1, 2, 3, 4, 5, 6, 7, 8, 9, A, b,…etc.
When you reach “1” press set SET .
The display will read	Thermostat Set Point High.
You are now in the CUSTOMER / SERVICE PARAMETERS.

-7-