VII. MICROPROCESSOR CONTROL (continued)
VII. j - SETTING THE 24-HOUR CLOCK:
The internal timeclock must be set in order for the data storage memory to correctly log events and to allow any defrost lock out to occur at the correct time of day. If the clock is not set, the control assumes the time is 12 a.m. at the time power is supplied to the unit. The hours on a
H01 = 1:00 a.m. | H07 | = 7:00 a.m. | H13 = 1:00 p.m. | H19 | = 7:00 p.m. |
H02 = 2:00 a.m. | H08 | = 8:00 a.m. | H14 = 2:00 p.m. | H20 | = 8:00 p.m. |
H03 = 3:00 a.m. | H09 | = 9:00 a.m. | H15 = 3:00 p.m. | H21 | = 9:00 p.m. |
H04 = 4:00 a.m. | H10 | = 10:00 a.m. | H16 = 4:00 p.m. | H22 | = 10:00 p.m. |
H05 = 5:00 a.m. | H11 = 11:00 a.m. | H17 = 5:00 p.m. | H23 | = 11:00 p.m. | |
H06 = 6:00 a.m. | H12 | = 12:00 p.m. | H18 = 6:00 p.m. | H24 | = 12:00 a.m. |
Follow the instructions to enter the customer access code on page 7. When the control
displays 
Thermostat Set High, press the down arrow key 
until the control
display reads
Clock. Press the set button SET .
The display will show 
Hours. The right two numbers will be flashing.
Use the arrow keys 
to set the hour.
When the correct hour is displayed, press the set button SET .
The display will show |
|
|
|
|
|
| Minutes. The right two numbers will be flashing. |
|
|
|
|
|
| ||
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Use the arrow keys to set the minutes 
.
When the correct minutes are displayed, press the set button SET .
The display will then read 
Thermostat Set Point High.
You can use the up or down arrow keys 
to scroll to the next parameter or wait 30 seconds for the control to return to normal operation.