True Manufacturing Company TCGDZ-50 installation manual Optional Installing Optional Formica KIT

Page 13

True Food Service Equipment, Inc.

INSTALLATION / OPERATION INSTRUCTIONS

OPTIONAL (INSTALLING OPTIONAL FORMICA KIT)

FORMICA KIT INSTALLATION:

FORMICA KIT COMPONENTS:

(2)Formica Top End Panels 103/4"w x 33"h (27.3 cm x 83.8 cm).

(2)Bottom End Panels

(1)left side, (1) right side (Formica glued to black plastic panel with 4 key hole slots).

(1)Formica Front Panel

width will vary x 75/8"h (19.4 cm)

NOTE

Please use care when installing the Formica. Formica can chip, crack, or break.

NOTE

Refer to image 1 for placement of Formica panels.

A. Install the front Formica panel.

Be sure bottom end panels are off in order to install front panel. Slide front panel into top and bottom tracks on the front of the cabinet. Make sure panel is even on both left and right end of the cabinet (images 1 & 2).

B. Install the top end Formica panels (one on each side.

Be sure bottom end panels are off in order to install top end Formica panel. Both top end panels are the same

STEP A

size so they each can be used for left or right of the cabinet.

Slide panel up into black plastic tracks on the top side panel of each end of cabinet (images 1 & 3).

Formica top

Formica top

Formica bottom

end panel

end panel

end panel will lock

will slide up

will rest on

through keyholes on

into plastic

screw.

backside of bottom

tracks.

 

end piece.

NOTE

After installing the bottom end pieces the top end panel will stay in place.

C.Install the bottom end Formica panels (one on each side.

(Formica is pre-glued to black plastic panel).

Line up the four keyhole slots in each bottom end piece to the (4) screws on the side of the cabinet. Slip the (4) large keyholes from the bottom end piece over the (4) screws. Then push down to fasten the bottom end piece onto the cabinet (images 1 & 3).

NOTE

The bottom left and right pieces are not the same. The taller part of the bottom end piece goes to the rear of the cabinet as shown in image 3.

1

STEP C

Four keyholes on backside.

Formica.

STEP B

Tracks to

2hold Formica.

STEP A

Side view of Formica sliding into place for front panel and

3top end panel.

11

www.truemfg.com

11

Image 13
Contents Curved Glass Display Cases True Manufacturing Company, Inc Safety Precautions USE of Extension Cords Proper Disposal of the Display CaseNever USE AN Adapter Plug For models with standard power cordRequired Tools Installation / Operation Instructions OwnershipUncrating True is not responsible for damage incurred during shipmentLocating Warranty is void if ventilation is insufficientLeveling Tools RequiredElectrical Instructions Conductors and Circuits Startup Replacement PartsRecommendation Shelf Installation Shelving Installation Refrigerated BakeryFor lights to work. If less than Attached caps are plugged intoCastor Installation Tools Required Optional Installing Optional CastorsFormica KIT Installation Formica KIT Components Optional Installing Optional Formica KITRefer to image 1 for placement of Formica panels Optional Sealing Cabinet to Floor Cabinet CleaningShelf Mounted Bulb Replacement Light Bulb ReplacementInterior TOP Bulb Replacement Danfoss Temperature Control Temperature Control Adjustment for High Altitude onlyTerms Controller functions closer to sea levelCondenser Cleaning Tools Required Cleaning the Condenser CoilImportant Warranty Information Stainless Steel Equipment Care and Cleaning Stainless Steel Equipment Care and Cleaning Warranty Information U.S.A. and Canada ONLY! U.S.A