True Manufacturing Company TCGDZ-50 installation manual For models with standard power cord

Page 5

True Food Service Equipment, Inc.

SAFETY INFORMATION

WARNING!

HOW TO CONNECT ELECTRICITY

Hard wiring is required on specific Display Cases.

Models standard with power cords: Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.

For personal safety, this appliance must be properly grounded.

Before your new display case is connected to a power supply, check the incoming voltage with a voltmeter. If anything less than 100% of the rated voltage for operation is noted, correct immediately.

Have the circuit checked by a qualified electrician to make sure it is properly grounded.

The display case should always be use it’s own indi- vidual electrical circuit, which has a voltage rating that matches the rating plate.

This provides the best performance and also pre- vents overloading building wiring circuits which could cause a fire hazard from overheated wires.

For models with standard power cord.

The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong (grounding) wall outlet to mini- mize the possibility of electric shock hazard from this appliance.

Have the circuit checked by a qualified electrician to make sure it is properly grounded.

If the outlet is a standard 2-prong outlet, it is your personal responsibility and obligation to have it replaced with the properly grounded 3-prong wall outlet.

The display case should always be plugged into it’s own individual electrical circuit, which has a volt- age rating that matches the rating plate.

This provides the best performance and also pre- vents overloading building wiring circuits which could cause a fire hazard from overheated wires.

Never unplug your display case by pulling on the power cord. Always grip plug firmly and pull straight out from the outlet.

Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end.

When removing the display case away from the wall, be careful not to roll over or damage the power cord.

USE OF ADAPTER PLUGS

NEVER USE AN ADAPTER PLUG!

NEMA plugs

TRUE uses these types of plugs. If you do not have the right outlet have a certified electrician install the correct power source.

115/60/1 NEMA-5-15R

3

www.truemfg.com

3

Image 5
Contents Curved Glass Display Cases True Manufacturing Company, Inc Safety Precautions USE of Extension Cords Proper Disposal of the Display CaseNever USE AN Adapter Plug For models with standard power cordRequired Tools Installation / Operation Instructions OwnershipUncrating True is not responsible for damage incurred during shipmentLocating Warranty is void if ventilation is insufficientLeveling Tools RequiredElectrical Instructions Conductors and Circuits Recommendation Replacement PartsStartup Shelf Installation Shelving Installation Refrigerated BakeryFor lights to work. If less than Attached caps are plugged intoCastor Installation Tools Required Optional Installing Optional CastorsRefer to image 1 for placement of Formica panels Optional Installing Optional Formica KITFormica KIT Installation Formica KIT Components Optional Sealing Cabinet to Floor Cabinet CleaningInterior TOP Bulb Replacement Light Bulb ReplacementShelf Mounted Bulb Replacement Danfoss Temperature Control Temperature Control Adjustment for High Altitude onlyTerms Controller functions closer to sea levelCondenser Cleaning Tools Required Cleaning the Condenser CoilImportant Warranty Information Stainless Steel Equipment Care and Cleaning Stainless Steel Equipment Care and Cleaning Warranty Information U.S.A. and Canada ONLY! U.S.A