Whirlpool FGP357Y warranty Removing the oven bottom, To replace, To reprace

Page 18

To replace:

1.Be sure the hinge arms are in the open position. Be careful if pulling the hinges open by hand. Hinges may snap back against the oven frame and could pinch fingers.

2.Hold the door at the sides near the top. Insert hinge arms into slots at the bottom of the door. Inaeti arms evenly, as far as they will go.

3.lf the door is not in line with the oven frame, remove it and repeat the above steps.

4.Replace the screws on the oven door.

Removing the oven bottom

The panel in the oven bottom can be removed for cleaning.

To remove:

1.Remove oven racks.

2.Remove the two hold-down screws at the rear of the oven. If screws are too tight to remove by hand, use a screwdriver.

3.Place fingers in slots in bottom panel and lift rear of panel up and back until lip at the front of panel is clear of front frame of oven cavity.

4.Lift bottom up and out.

m

To reprace:

1.Place oven bottom panel in oven with the back raised about 6 inches or until you can insert the hold-down lip at front of panel under the front frame of oven cavity.

2.Push back of oven bottom panel down fully into place on metal flanges on rear wall and insert the hold-down screws.

16

Image 18

Contents UseAndCare Your safety is important to us Thank you for buying a Roper applianceFor further information, see ‘The anti-tip bracket on General When using the cooktop Know where your main gas shutoff valve is locatedWhen using the oven PartsAnd Features Control PanelsThis Section Using the surface burnersBurner heat settings Surface burner markersCase of a prolonged power failure Cookware tipsTo serve Home canning information Positioning racksPans 6th oven rack position Roasting rackFor best air circulation Place in the center of the oven rackPlace in opposite corners of the oven rack Setting the clock Using the Minute TimerAdjusting the oven temperature control Baking/roastingCookbook for broiling chart BroilingOne of the three levels. Refer to a reliable Energy saving tips Oven ventAnti-tip bracket Caring For Your Range Surface burner gratesSurface burners and cooktop Cleaning the contoured well areasCleaning the burners Burner caps should be routinely removedRemovina the oven door To removeBurner cap and trim ring Removing the oven bottom To replaceTo reprace Cleaning chart Part I What to USE Oven light To replace the oven lightBurner ports are clogged Let dry Push control knobs in before turning to a settingBefore calling for assistance TurningIf you need assistance If you need serviceIf you are not satisfied with how the problem was solved For further information, write to Mr. William ClarkRoper From date of purchase