Whirlpool FGP357Y warranty Positioning racks, Pans, Home canning information

Page 9

Home canning information

The large diameter of most water-bath or pressure canners combined with high heat settings for long periods of time can cause damage to the cooktop.

To protect your range:

l

l

l

For best results, use a canner which can be centered over the surface burner.

Do not place canner on two surface burners at the same time. Too much heat will build up and will damage the cooktop.

Start with hot water. This reduces the time the control is set on high. Reduce heat setting to lowest position needed to keep water boiling.

Positioning racks and

For baking/roasting with one rack, place the rack so the top of the food will be centered in the oven.

Rack placement for specific foods:

I

 

FOOD

1 RACK POSITION

r

 

1st or 2nd rack

 

Frozen pies, large roasts,

 

turkeys

 

auide from bottom

When baking on two racks, arrange racks on first and third rack guides from bottom.

pans

Personal Injury Hazard

lAlways position oven rack(s) in desired

1location before turning oven on. Be sure the rack(s) is level.

lIf rack(s) must be moved while oven is hot, use potholders or oven mitts to protect hands.

lDo not place items on the open oven door.

lBe careful when installing and removing large food items from sixth rack position. Food will be close to hot surfaces, including oven bottom and sides.

Failure to follow the above precautions may result in personal injury.

6th oven rack position

(roasting rack)

When roastina food too larae to be Dlaced in oven with rack in lowest po‘;ition, piace rack on bottom of oven.

For proper roasting, follow these guidelines: l The rack must be level.

lUse adequate amount of liquid (meat juices or water) so food does not get overdone.

lDo not try to pull rack out over door. Rack will be at the same level as door when door is opened.

oven rack position

9

Image 9
Contents UseAndCare Your safety is important to us Thank you for buying a Roper applianceFor further information, see ‘The anti-tip bracket on General Know where your main gas shutoff valve is located When using the cooktopWhen using the oven Control Panels PartsAnd FeaturesBurner heat settings Using the surface burnersThis Section Surface burner markersCase of a prolonged power failure Cookware tipsTo serve Pans Positioning racksHome canning information 6th oven rack position Roasting rackFor best air circulation Place in the center of the oven rackPlace in opposite corners of the oven rack Using the Minute Timer Setting the clockBaking/roasting Adjusting the oven temperature controlCookbook for broiling chart BroilingOne of the three levels. Refer to a reliable Energy saving tips Oven ventAnti-tip bracket Surface burner grates Caring For Your RangeCleaning the burners Cleaning the contoured well areasSurface burners and cooktop Burner caps should be routinely removedRemovina the oven door To removeBurner cap and trim ring Removing the oven bottom To replaceTo reprace Cleaning chart Part I What to USE To replace the oven light Oven lightBefore calling for assistance Let dry Push control knobs in before turning to a settingBurner ports are clogged TurningIf you are not satisfied with how the problem was solved If you need serviceIf you need assistance For further information, write to Mr. William ClarkFrom date of purchase Roper