SET. Repeat to designate the minute of the timer on time.
After you designate the
3Press the DOWN or UP button to select a source, and press SET.
• If the TUNER button is pressed, the band cannot be selected in this step.
|
|
|
|
| CLOCK AND TIMER (cont) | pg. 30 |
|
|
|
|
|
| 4 Select the duration for the | DOWN or | UP button, and press |
| SET. |
|
|
The duration for the
5 Prepare the source.
To listen to a CD, load the disc to be played first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
To listen to an MD, insert the MD into the disc drive
•6 Press POWER to turn the unit off after adjusting the volume and tone.
remains on the display after the power is turned off (timer standby mode).
When the
The volume level is automatically set to 16 when the power is turned off with the volume level set to 17 or more.
To check the specified time and source
Press TIMER while pressing SHIFT. The
To cancel timer standby mode temporarily
Press TIMER while pressing SHIFT so that •or •REC disappears on the display.
To restore the timer standby mode, press again to display •or •REC.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before the turning off the power, repeat step 5 to prepare the source, and adjust the volume and tone.
NOTE
•Timer playback and timer recording will not begin unless the power is turned off.
•Connected equipment cannot be turned on and off by the b
SETTING THE TIMER RECORDING
Timer recording is applicable for TUNER and
1 Press the TIMER button repeatedly until •REC appears, and press the button within 4 seconds.