Installation Instructions
The refrigerator temperature will vary depending on the quantity of food stored and the frequency with which the door is opened.
NOTES:
•This appliance is intended for
•Before connecting this appliance to electrical power supply, leave it to stand for approx. 24 hours, which will reduce the possibility of malfunction in the cooling system due to transport handling.
•This appliance is approved for INDOOR USE ONLY and is NOT intended for outdoor operation.
DOOR REVERSAL INSTRUCTIONS
IMPORTANT
Install this appliance in an area where the ambient temperature is between 55°F (13°C) and 110°F (43°C). If the temperature around the appliance is too low or high, cooling ability may be affected.
Your refrigerator is built with a reversible door. You have the choice of either opening it from the left or the right side. In order to reverse the opening direction of your door, please follow these simple instructions:
IMPORTANT
Before you begin, unplug refrigerator or disconnect power. Remove food and any adjustable door or utility bins from doors.
DOOR AND HINGE REMOVAL
1.Unplug refrigerator or disconnect power.
2.Keep both doors closed until you are ready to lift them free from the cabinet.
NOTE: Provide additional support for the doors while the hinges are being moved. Do not depend on the door magnets to hold the doors in place while you are working.
3.Remove the parts for the top hinge as shown in Top Hinge graphic. Lift the freezer door from the cabinet.
4.Remove the parts for the center hinge as shown in the Center Hinge graphic. Lift the refrigerator door free from the cabinet.
5.Remove the parts for the bottom hinge as shown in the Bottom Hinge graphic. (see page 5)
DOOR REVERSAL CABINET
1.Remove the cover of upper hinge hole from left side and move them to opposite side (see Graphic 1).
2.Remove hole plugs from left side and move them to opposite side (see Graphic 2 on page 5)
DOORS
1.Remove door hinge hole plug from the top of freezer and refrigerator door (see graphic 4 on page 5)
2.Remove the door stop from refrigerator door and move to the other side (see graphic 5 on page 5)
3.Take out the left door stop of freezer door and screw from the accessory bag and fix it on the handle (see graphic 3 on page 5)
4