RefrigeratorDoor
Install and Remove Handles
Graphics are included later in this section.
1.Place handle on the door or drawer as shown.
2.Using a Phillips screwdriver, attach the handle to the door with the handle screws.
3.Place the handle trim pieces on the handle ends as shown.
4.Using your hand, apply firm pressure on the face of the trim and slide the trim piece toward the center of the handle.
5.To remove handles, reverse directions.
Remove Freezer Drawer
Graphics are included later in this section.
IMPORTANT: Two people may be required to complete this procedure.
1.Open the freezer drawer to full extension.
2.Remove all articles from baskets.
3.Pull the upper wire basket out to full extension and lift out to remove.
4.Lift lower basket straight up and out to remove.
5.Remove the basket cradles from the drawer rails. Push the snap attachments inward away from the drawer rails to unlatch the basket cradles. Lift the basket cradles off of the drawer rails.
A
B
Replace Freezer Drawer
IMPORTANT: Two people may be required to complete this procedure.
1.Pull both drawer rails out to full extension.
2.Locate the notches on the inside of each drawer rail. See Graphic
3.While supporting the drawer front, hook the drawer supports into the notches on the inside of the drawer rails. Lower the drawer front into its final position. See Graphic
4.Place the basket cradles back on the drawer rails. Align the snap attachments with the slots on the drawer rails, and press each snap toward the rail until it clicks.
5.With drawer rails pulled out to full extension, set the lower basket straight down into the basket cradles.
6.Slide the upper basket into the molded drawer rail. Make sure the rear of the basket hooks behind the drawer rail stop.
Remove Door and Hinges
IMPORTANT:
■Unplug refrigerator or disconnect power. Remove food and any adjustable door or utility bins from doors.
■All graphics referenced in the following instructions are included later in this section after “Final Steps.”
TOOLS NEEDED: ⁵⁄₁₆", ³⁄₈", ¹⁄₄"
⁵⁄₁₆"
1.Keep the refrigerator door closed until you are ready to lift it free from the cabinet.
NOTE: Provide additional support for the doors while the hinges are being moved. Do not depend on the door gasket magnets to hold the doors in place while you are working.
2.Remove the parts for the top hinge as shown in Top Hinge graphic. Lift the refrigerator door free from the cabinet.
3.Remove the parts for the bottom hinge as shown in Bottom Hinge graphic.
A. Cradle snap attachment
B. Basket cradle
6.Lift the top of the freezer drawer front to disengage drawer rail hooks from drawer rails. Lift drawer out.
7