Changing the Light Bulbs
NOTE: Not all bulbs will fit your refrigerator. Be sure to replace the | 3. Plug in refrigerator or reconnect power. | |
bulb with an appliance bulb of the same size, shape, and wattage. |
| |
1. | Unplug refrigerator or disconnect power. |
|
2. | Remove the bulb from behind the control panel in the |
|
| refrigerator or from behind the light shield in the freezer (on |
|
| some models). Replace it with an appliance bulb of the same |
|
| wattage. |
|
TROUBLESHOOTING
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
In the U.S.A., www.whirlpool.com In Canada, www.whirlpool.ca
Refrigerator Operation
The refrigerator will not operate
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
■Power cord unplugged? Plug into a grounded 3 prong outlet.
■Is outlet working? Plug in a lamp to see if the outlet is working.
■Household fuse blown or circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.
■Control(s) on? Make sure the refrigerator control is on. See “Using the Control(s).”
■New installation? Allow 24 hours following installation for the refrigerator to cool completely.
NOTE: Adjusting the temperature control(s) to coldest setting will not cool the refrigerator more quickly.
The motor seems to run too much
Your new refrigerator may run longer than your old one due to its
The refrigerator seems noisy
Refrigerator noise has been reduced over the years. Due to this reduction, you may hear intermittent noises from your new refrigerator that you did not notice from your old model. Below are listed some normal sounds with explanations.
■Pulsating - fans/compressor adjusting to optimize performance.
■Hissing/Rattling - flow of refrigerant, movement of water lines, or from items placed on top of the refrigerator.
■Popping - contraction/expansion of inside walls, especially during initial
■Water running/dripping - may be heard when ice melts during defrosting and water runs into the drain pan.
The door will not close completely
■Door blocked open? Move food packages away from door.
■Bin or shelf in the way? Push bin or shelf back in the correct position.
■Crisper cover in the way? Make sure the crisper cover is fully pushed in, so that the back rests on the supports.
The door is difficult to open
WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
■Gaskets dirty or sticky? Clean gaskets and contact surfaces with mild soap and warm water. Rinse and dry with soft cloth.
10