Whirlpool GI15NDXZS, GI15NDXZQ, GI15NDXZB Vacation and Moving Care, To Shut Down the Ice Maker

Page 16

11.Wash the interior components (cutter grid, exterior of hoses, and water pan) and the storage bin, door gasket, ice scoop, and ice scoop holder with mild soap or detergent and warm water. Rinse in clean water. Then clean the same parts with a solution of 1 tbs (15 mL) of household bleach in 1 gal. (3.8 L) warm water. Rinse again thoroughly in clean water.

NOTE: Do not remove hoses. Do not wash plastic parts in dishwasher. They cannot withstand temperatures above 145°F (63°C).

12.To replace the water pan, set the water pan inside the ice bin. Hook up the water pan pump. Snap the pump bracket back onto the water pan and place back into position. Secure the water pan by replacing the mounting screw.

13.Check the following:

■Drain cap from the water pan is securely in place. If the drain cap is loose, water will empty from the water pan, and you will have either thin ice or no ice.

■Hose from water pan is inserted into storage bin drain opening.

14.Slide the cutter grid back into place and secure it by replacing the right-hand screw and plastic spacer. Then tighten the left-hand screw. Reconnect the cutter grid harness and the ice level sensor harness.

15.Replace the cutter grid cover.

16.Gently wipe the control panel with a soft, clean dishcloth using warm water and a mild liquid dish detergent.

17.Plug in ice maker or reconnect power.

18.After cleaning, make sure that all controls are set properly and that no control indicators are flashing.

Vacation and Moving Care

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

To Shut Down the Ice Maker:

1.Unplug ice maker or disconnect power.

2.Remove all ice from storage bin.

3.Shut off the water supply.

4.Remove the 2 screws in the lower access panel and the

2 screws from the base grille area of the front panel support. Pull forward to remove the lower access panel.

5.Disconnect the inlet and outlet lines to water valve. Allow these lines to drain and then reconnect to the valve.

6.Replace lower access panel and screws.

7.Drain water from water pan by removing the drain cap.

8.If the room temperature will drop below 32°F (0°C), water must be removed from the drain line.

For Ice Makers with a Drain Pump Installed:

■Plug in ice maker or reconnect power.

■Turn ice maker off and remove all remaining ice from ice bin.

■Pour 1 qt (0.95 L) of water into the ice bin near the drain and let the ice maker stand for approximately 5 minutes. This will allow the water in the bin to drain into the drain pump so that the pump will remove the remaining water from the ice bin and the drain pump.

■Unplug ice maker or disconnect power.

9.Before using again, clean the ice maker and storage bin.

10.Plug into a grounded 3 prong outlet.

NOTE: All components of the ice maker are permanently lubricated at the factory. They should not require any additional oiling throughout the normal life of the machine.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents ICE Maker W10518926BÍndice Table of ContentsTable DES Matières ICE Maker Safety Installation InstructionsCleaning Before Use Unpack the Ice MakerLocation Requirements Electrical RequirementsWater Supply Requirements Recommended Grounding MethodRear View Connecting the Water Line Vacation or Extended Time Without UseConnect Water Supply Tools NeededIce Maker Drain Pump Installation If Ice Maker Is Currently InstalledKit Contains Drain CapDrain Pump Installation Drain Pump InstalledRear Panel Drain TubeVent Tube Drain ConnectionGravity Drain System Connecting the Drain Ice Maker Door Reversal Side Swing OnlySide View Drain Pump System on some modelsDoor Stop and End-Cap Reversal Reverse HingesReplace Door Replace Door Wrap on some modelsInstall the Water Filter LevelingWater Filtration System Reverse Door CatchICE Maker USE How Your Ice Maker WorksWater Filter Status Light Replace the Water FilterUsing the Controls Fast Ice ModeClean Door Ajar AlarmCleaning ICE Maker CareExterior Surfaces Ice Maker SystemInterior Components Vacation and Moving Care For Ice Makers with a Drain Pump InstalledTo Shut Down the Ice Maker Troubleshooting Ice Maker OperationIce Maker Will Not Operate Ice Maker Seems NoisyIce Quality Ice ProductionIce Maker Runs But Produces No Ice If you need replacement parts U.S.ACanada Our consultants provide assistance withPerformance Data Sheet AccessoriesWhirlpool Corporation Major Appliance Warranty This limited warranty does not coverSeguridad DE LA Fábrica DE Hielo Su seguridad y la seguridad de los demás es muy importanteInstrucciones DE Instalación Desempaque la fábrica de hieloRequisitos de ubicación Requisitos eléctricosVacaciones o tiempo prolongado Sin uso Requisitos del suministro de aguaConexión del suministro de agua Vista posterior Instalación de la bomba de desagüe de La fábrica de hieloEl juego contiene Si la fábrica de hielo ya está instalada Tapa de desagüeLínea de suministro de agua Instalación de la bomba de desagüeTubo de desagüe Ranura de la lengüeta de montaje de la bomba de desagüeUbicaciones de las piezas Bomba de desagüe instaladaConexión del desagüe Tubo de ventilaciónSistema de desagüe por gravedad Vista lateralSistema de la bomba de desagüe en algunos modelos Conexión del desagüeCómo volver a colocar la puerta Inversión de las bisagrasBisagra superior Bisagra inferior NivelaciónCómo invertir el seguro de la puerta Sistema de filtración de agua Instalación del filtro de aguaCómo funciona su fábrica de hielo USO DE LA Fábrica DE HieloUso de los controles Sonidos normales Cuidado DE LA Fábrica DE HieloLimpieza Condensador Un condensador sucio u obstruido Bandeja de agua Tapón de desagüeComponentes interiores Tornillo Espaciador de plástico Rejilla de corteCuidado durante las vacaciones y mudanzas Para apagar la fábrica de hieloFuncionamiento de la fábrica de hielo Solución DE ProblemasLa fábrica de hielo no funciona Calidad del hielo Producción de hieloLa fábrica de hielo funciona pero no produce hielo Ayuda O Servicio Técnico Problemas de plomeríaEn los EE.UU Hoja DE Datos DEL Rendimiento AccesoriosFiltro de agua LimpiadorGarantía Limitada Esta garantía limitada no cubreSécurité DE LA Machine À Glaçons Votre sécurité et celle des autres est très importanteInstructions D’INSTALLATION Exigences d’emplacementDéballage de la machine à glaçons Enlèvement des matériaux d’emballageSpécifications électriques Spécifications de l’alimentation en eauVacances ou longue période ’inutilisation Raccordement à la canalisation d’eauRaccordement du tuyau d’eau Outillage nécessaireVue arrière Si la machine à glaçons est installée Installation de la pompe de vidangeContenu de l’ensemble Bouchon de vidangePanneau arrière Tube de vidangeEncoche de patte de montage de la pompe de vidange Position des piècesPompe de vidange installée Tube de ventilationRaccordement de vidange Vidange par gravitéVue latérale Système avec pompe de vidange sur certains modèlesClé de ¹⁄₄ Tournevis Phillips Réinstallation de la porte Réinstallation du revêtement de porte sur certains modèlesInversion du sens de montage des charnières Charnière inférieureNivellement Installer le filtre à eauSystème de filtration d’eau Remplacement du filtre à eau Utilisation DE LA Machine À GlaçonsFonctionnement de la machine à glaçons Témoin lumineux de l’état du filtre à eauUtilisation des commandes Mode Fast Ice glaçons rapidesAlarme de porte entrouverte Bruits normauxEntretien DE LA Machine À Glaçons NettoyageSurfaces extérieures Système de la machine à glaçonsComposants intérieurs Arrêt de la machine à glaçons Précautions à prendre avant les vacances ou un déménagementMachine à glaçons avec pompe de vidange Dépannage La machine à glaçons ne fonctionne pasProduction de glaçons Qualité des glaçonsAssistance OU Service Problèmes de plomberieAux États-Unis Si vous avez besoin de pièces de rechangeAccessoires Au CanadaFeuille DE Données SUR LA Performance Système de filtration d’eau de la machine à glaçonsLa présente garantie limitée ne couvre pas Garantie DES Gros Appareils Ménagers Whirlpool CorporationW10518926B

GI15NDXZS, GI15NDXZQ, GI15NDXZB specifications

The Whirlpool GI15NDXZB, GI15NDXZQ, and GI15NDXZS are versatile and stylish ice makers designed to enhance any kitchen or home bar area. These models stand out for their sleek design, compact size, and user-friendly features, making them ideal for those looking to enjoy the luxury of freshly-made ice at home.

One of the main features of these models is their production capacity. Each unit can produce up to 35 pounds of ice per day, ensuring that you never run out, whether you're hosting a party or enjoying a quiet evening at home. The ice maker uses a state-of-the-art compressor cooling system which not only supports efficient production but also helps maintain consistent ice quality. The bin capacity is also impressive, accommodating up to 28 pounds of ice, meaning less frequent refills and more convenience for users.

In terms of design, these models boast a modern stainless steel exterior, with finishes available in bold black, classic white, and sleek stainless steel. This variety allows for easy integration into any kitchen decor or style. The reversible door feature adds flexibility in placement, making it easy to fit the unit in different spaces.

The Whirlpool GI15NDXZB, GI15NDXZQ, and GI15NDXZS also integrate innovative technologies that enhance functionality. One such technology is the advanced filtration system that improves water quality, ensuring that the ice produced is crystal clear and tastes great. The units are designed with a quiet operation feature, making them suitable for any environment, including open-concept spaces or entertainment areas.

Moreover, these models include an automatic shutoff feature that activates when the ice bin is full, preventing overflow and minimizing waste. They also have a simple control panel that allows users to easily turn the machine on and off, as well as monitor the ice production status.

Maintenance is straightforward, with a removable ice bin that simplifies cleaning and filling. The interior surfaces are designed for easy wipe-down, helping to maintain hygiene with minimal effort.

In summary, the Whirlpool GI15NDXZB, GI15NDXZQ, and GI15NDXZS ice makers combine efficiency, style, and convenience. With their robust ice production capabilities, modern aesthetics, and user-friendly features, these units make a valuable addition to any home, enabling users to enjoy cold drinks and ice in a hassle-free manner.
Top Page Image Contents