Whirlpool DISHWASHERS Adding a dish during a cycle, Changing a cycle setting, Changing an option

Page 8

Adding a dish during a cycle

You can add an additional item to the dishwasher anytime before the Cycle Control knob reaches LIGHT WASH. See page 10.

1.Lift up on the door latch to unlatch the door and stop the cycle. Wait a moment for the spray action to stop before open- ing the door.

2.Open the door and add the dish.

3.Close the door. Do not latch it. Wait 30 seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle.

4.Press door in to latch it. The dishwasher will start where it stopped.

Changing a cycle setting

You can change a setting any-time during any cycle.

1.Lift up on the door latch to unlatch the door and stop the cycle.

2.Turn the Cycle Control knob clockwise to the cycle you want.

3.Push the desired Cycle Selection button.

4.Check the detergent dispense‘r to be sure it is properly filled for the new cycle. See page 11.

NOTE: Turning the Cycle Control knob may cause the covered section of the detergent dispenser to open. Be sure to fill the covered section if the cycle uses detergent in both sections.

Close and latch the door. The dishwasher will automatically start the new cycle.

Changing an option

You can change an option anytime during a cycle. To change the selected option(s):

1.Push the RESET OPTIONS button.

2.Push an Option Selector button for each desired option.

Canceling a cycle

You can cancel a cycle any-lime during the cycle.

1.Turn the Cycle Control knob slowly clockwise to the drain portion of the wash or rinse. You will hear water draining when you have advanced to the proper location.

2.Let the dishwasher drain completely.

3.Lift up on the door latch to unlatch the door.

4.Turn the Cycle Control knob clockwise to point to OFF.

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Series Dishwashers Your safety is important to us Thank you for buying a Whirlpool@ applianceHelp us help you DishwasherParts And Features Power CleanCycle control knob Control panelButtons Using Your Dishwasher Before starting your dishwasherStarting your dishwasher ThisStarting your dishwasher using delay wash Clean signal lightChanging a cycle setting Canceling a cycleAdding a dish during a cycle Changing an optionCycle selection chart What happens in each option Hi-Temp Wash optionUsing the detergent dispenser Air Dry optionWhat type of detergent to use Detergent dispenserUsing the rinse agent dispenser How much detergent to useRinse agent dispenser To check dispenserQuiet operating tips To fill dispenserEnergy saving tips Water temperature tipsTo check water temperature Special tips on dishwasher use Loading Your Dishwasher Preparing to load the dishwasherLoading the top rack This SectionAdjustable 3-position top rack Infinite adjustable top rackMixed load Utensil loadLoading the bottom rack Dish loadLoading the silverware basket To remove the basketTo replace the basket To open the basketWhile dishwasher is running Connecting a Portable DishwasherBefore starting Converting to built-in When cycle is finishedElectrical connection Cleaning the exterior Cleaning the interiorCaring For Your Dishwasher Caring for simulated wood topCommon Dishwashing Problems Solution chartInsufficient fill caused by low water pressure Removing spots and film If You Need Assistance Or Service Before calling for assistanceIf you need service If you are not satisfied with how the problem was solvedIf you need assistance If you need FSP@ replace- ment partsPower Cleantm washing system parts covered by your warranty Dishwasher Warranty Whirlpool
Top Page Image Contents