Bosch Appliances HGEW 36 FS Electrical Connection, Install Electrical Service, Electrical Data

Page 7

PRIOR TO INSTALLATION

Step 3: ELECTRICAL CONNECTION

WARNING: THIS APPLIANCE MUST BE GROUNDED

The hood should only be connected to a grounded socket that has been installed according to relevant regulations.

If possible, site the earthed socket directly behind the chimney paneling.

The grounded socket should be connected via its own circuit.

If the grounded socket is no longer accessible following installation of the hood, ensure that there is a permanently installed disconnector.

Step 4: INSTALL ELECTRICAL SERVICE

Check your local building codes for proper method of installation. In the U.S., if there are no applicable local codes, this unit should be installed in accordance with the National Electric Code ANSI/NFPA No. 70, Current Issue. (In Canada, installation must be in accordance with the CAN 1- B149.1 and .2 - Installation Codes for Gas Burning Appliances and/ or local codes).

The appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.

WARNING – Improper grounding can result in a risk of electric shock.

Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.

Do not use an extension cord. If the power supply cord is too short, have a qualified electrician install an outlet near the appliance.

If it is necessary to wire the hood directly into the mains:

WARNING – Avoid risk of electrical shock – If the connecting cable for this appliance is damaged, the cable must be replaced by the manufacturer or his customer service or a similarly qualified person in order to prevent serious injury to the user.

ELECTRICAL DATA:

Are to be found on the name plate inside the appliance after removal of the filter frame.

WARNING – Avoid risk of electrical shock – Before undertaking any repairs, always disconnect the hood from the electricity supply.

Length of the connecting cable: 511/8”.

This hood corresponds to EC regulations concerning RF interference suppression.

7

Image 7 Contents
Useinstallationand Caremanuall Página Parts Needed Safety InstructionsRead All Instructions Before Using the Appliance Read and Save These InstructionsAdditional information concerning gas cookers Important InformationEXHAUST-AIR Mode Prior to InstallationExhaust air should neither be directed Mount the duct directly onto the air out- let on the hood Connecting a l 6 EXHAUST-AIR DuctFor optimum hood efficiency Preparing the WallElectrical Connection Install Electrical ServiceElectrical Data Page Installation InstallationInstallation Installation Pièces nécessaires Instructions DE SécuritéLire toutes les instructions avant d’utiliser l’appareil Lire ET Conserver CES Instructions AvertissementInformations supplémentaires Information ImportanteConcernant les cuisinières à gaz Étape 1 Mode D’ÉVACUATION D’AIR Avant L’INSTALLATIONPoids en kg Raccordement DUN Conduit Dévacuation Dair DE 6 PO. lÉtape 2 Préparation DU MUR Le mur doit être plat et perpendiculaireÉtape 3 Branchement Électrique Étape 4 Installation DE LA Servitude ÉlectriqueDonnées Électriques Page Étape 5 Installation Evitez dendommager les surfaces lisses en acier inox Installation Piezas necesarias Piezas incluidas Instrucciones DE SeguridadLea todas las instrucciones antes de usar el aparato LEA Y Guarde Estas Instrucciones AdvertenciaInformación adicional sobre estufas Información ImportanteGas Paso 1 Modo DE Aire DE Salida Antes DE LA InstalaciónPara Conectar UN Conducto DE Aire DE Salida DE l Para obtener la máxima eficiencia de la campana extractoraPaso 2 Preparación DE LA Pared Paso 4 Instale EL Servicio Eléctrico Paso 3 Conexión EléctricaDatos Eléctricos Page Instalación InstalaciónEnroscar el tornillos inferior tornillos hexagonal Instalación Page Noticias 9000 326