Blodgett SN-5G manual Periodic Maintenance Cleaning

Page 15

5.0PERIODIC MAINTENANCE

NOTICE: As a safety precaution, disconnect the power supply during cleaning or servicing.

CLEANING

At the end of each day, or between cooking cycles if necessary:

1.Turn main power switch OFF.

2.Remove pans and racks from compartment and wash in sink.

3.Wash compartment interior with clean water.

4.Use warm soapy water with a cloth or sponge to clean exposed bead of door gasket, rinse with warm clear water and wipe with a dry cloth.

Wipe surfaces which touch door gasket with a cloth or sponge and warm soapy water, rinse with warm clear water and wipe with a dry cloth. Do not apply food oils or petroleum solvents or lubricants directly to door gasket or surfaces which touch door gasket.

5.Remove drain screens from inside compartment drains. Using a plastic bottle brush and mild detergent, clean inside the drain opening ensuring there is no food residue or blockage. Clean the drain screen and replace in its original position.

6.Leave door slightly open when steamer is not in use.

CAUTION: Do not use cleaning agents that are corrosive.

NOTICE: Contact the factory, the factory representative or a local service company to perform maintenance and repairs should the appliance malfunction. Refer to warranty terms.

15

Image 15
Contents SN-5G, SC-7G and SC-10G Important Notes for Installation and Operation Table of Contents Water Quality Statement Service Connections SN-5GModel GAS Supply Service Connections SC-7G and SC-10GExhaust Fans and Canopies Installation GeneralTo Install Wall Exhaust FANClearances GAS Connection Drain Connections Figure VAC-60 Hz-Single PhaseWater Conditioning Cold Water CondenserPerformance Check Controls Operation InstructionsLighting Shutdown Stand byComplete Shutdown Number of Pans Depth SN-5G SC-7G Steam CookingPreparation PANPeriodic Maintenance Cleaning Weekly, or more often if necessary MonthlyNever Spray Water Into Electric Controls Removal of Scale Deposits Maintenance Stainless SteelRUB with a Circular Motion To Remove Heat TintUSE Deliming Procedure For units equipped with this featureTroubleshooting Burner does not come onBurner produces carbon deposits Water flows into drain during shut down Water flows into cooking compartmentDoor leaks Water accumulates in the compartment