Blodgett SN-5G manual Service Connections SC-7G and SC-10G, Model GAS Supply

SERVICE CONNECTIONS – SC-7G and SC-10G

Unless otherwise specified, Field Wire Electrical Connection to be 120 Volts, 60 Hertz single phase withgrounding wire. Furnished with 6 foot cord with 3 prong plug. Maximum amps 4.0.

DRAIN: 1"IPS piped to open floor drain. No Solid Connection. 24" length before open air gap opening. (No bends or elbows)

GAS CONNECTION: 3/4"IPS supply line required.

GENERATOR WATER: 3/8" O.D. tubing at 25-50 PSI(170-345 kPa)

CONDENSING WATER: 3/8" O.D. tubing at 25-50 PSI(170-345 kPa)

WATER QUALITY STATEMENT

Water quality is the major factor affecting the performance of your appliance. If you are unsure of water quality, consult a local water treatment specialist and have the water analyzed. Your water supply must be within these general guidelines:

Total dissolved solids	Less than 60 PPM
Total alkalinity	Less than 20 PPM
Silica	Less than 13 PPM
Chlorine	Less than 1.5 PPM
pH Factor	7.0-8.5

Water which fails to meet these standards should be treated by installation of water conditioner.

FAILURE OR MALFUNCTION OF THIS APPLIANCE DUE TO POOR WATER QUALITY IS NOT COVERED UNDER WARRANTY.

MODEL			GAS SUPPLY
	BTU/HR.	kW/HR.		SUPPLY PIPE PRESSURE (W.C.)
SC-7G	90,000	26.4	Natural - min. 6"(152mm)		Propane - min. 11"(279mm)
SC-10G	90,000	26.4	Natural - min. 6"(152mm)		Propane - min. 11"(279mm)

DIMENSIONS ARE IN INCHES [MM]
										24 [610]
	1 [25]									2.75 [70] SC-7G
		12 [305]								1.75 [44] SC-10G
										4 [102] SC-7G
										3 [76] SC-10G
									9 [229]	3.50 [89]
	SAFETY RELIEF									6.25 [159] SC-7G
										5.25 [133] SC-10G
	VALVE
20 [508]	1 [25]			SC-7G	SC-10G	76.25 [1937] SC-7G	76.13 [1934] SC-10G	4 [102]	1.13 [29]	33 [838]
			SC-10G
	1.75 [44]									REAR FLANGED FOOT DETAIL
	[152]6	12 [305] SC7G-	10 [254]	23.75[603]	21.63[549]			16.75 [425]		2 EQUALLY SPACED
										Ø7/16" [11mm] HOLES
										ON 2.5 [63] B.C.
							5