Installing the Hood
www.zephyronline.com
A
Fig.11 | Fig.12A |
Installation –
10)Place 6” round ducting over blower collar and secure with aluminum duct tape. If using hood in ductless recirculating mode turn to page 13.
Install electrical wiring. Note: A cable lock (not included) may be required by local codes. Check with local requirements and codes, purchase and install appropriate connector if necessary.
Make sure no packing material is inside hood. Power up hood check for leaks around duct tape and verify all functions.
11)Secure (2) 1” wood screws (A) into the screw holes on the left and right sides of the fi lter opening. This will secure the hood body to the cabinet base and prevent the hood from shifting after installation.
Fig.12B
12)Place front panel back on hood body and secure in place by using the (10) screws previously removed from step 2.
12