Zephyr ZGE-E36AS, ZGE-E30AS Control Optional, Remote Control Features, Remote Control Maintenance

Page 18

Control (Optional)

www.zephyronline.com

FCC Caution: To assure continued compliance, any changes or modifi cations not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Remote control is sold as an optional accessory. Purchase Zephyr part number: 14000005

This remote control may operate in humid environments, but not when placed on a wet surface.

SYNCHRONIZATION: To create a unique link between your range hood and remote control please follow the below steps:

1.With range hood off, press and hold the “lights” button on the range hood until the letter “F” shows on the display screen.

2.Press the “lights” button on the remote, the lights on the hood will turn on. The synchronization is complete.

REMOTE CONTROL FEATURES:

The RF remote control is equipped with a magnet for easy storage. The remote may be placed on any magnetic surface such as a refrigerator or the Zephyr remote holder. Maximum remote control communication distance from power pack is 15 feet.

& Controls – Remote

Blower On/

1

Blower On/

Speed Selection

2 Power Off

5 Min Delay Off 3

4 Lights On/Dim/Off

1Blower On/Speed Selection

By pressing , the blower is switched On. Press again to cycle through all three blower speeds.

2Blowers On/Hood Off

By pressing , the blowers will power on at the last speed setting. Press again and the entire hood will power off, including lights.

3Delay Off

By pressing , the blower and lights will enter Delay Off mode. A dot will appear in the lower right corner of the power pack display indicating the function is on. The blower will change to speed 1 and shut down after 5 minutes.

4Lights On/Dim/Off

Switch lights On by pressing once, again to dim and again to switch Off.

Features

 

 

 

REMOTE CONTROL MAINTENANCE:

 

 

 

Clean the remote control using non abrasive detergents

 

 

 

Follow instructions below for replacing battery.

 

 

 

Using a small fl at head screwdriver, raise the cover of the battery door (A)

 

 

 

in order to access the battery compartment.

+

A

-

Remove the battery and replace with Type A23 12V.

 

 

Negative end of battery should face the spring inside the remote.

Replace battery door and recycle old battery.

16

Image 18
Contents Use, Care, and Installation Guide Page Table of Contents InstallationImportant Safety Notice Read and Save These InstructionsOperation List of Materials Parts not SuppliedInstallation Ducting Calculation Sheet Duct pieces Equivalent number Total Length x usedInstallation Installing the Hood DuctingInstallation Ducting Options Ducting Options ExampleInstallation Hood Specifications Top of hoodInstallation Preparing the Cabinet Open cabinet doors. Lift range hood and slide it through Installing the Hood Installation Hood Model Filters in Pkg ZGE all models Installation Ductless RecirculationRecirculating KIT Required if not Ducted Outside the Home Hood Model Qty to Order ZGE all modelsFeatures & Controls Touch Controls Speed SelectionReminder Filter CleanFeatures ReplaceFollow instructions below for replacing battery Remote Control FeaturesRemote Control Maintenance Control OptionalHood and Filter Cleaning MaintenanceSurface Maintenance Maintenance Lights Replacing Light BulbsMaintenance Wiring Diagram Troubleshooting Troubleshooting Procedures for GenovaIssue Cause What to do Optional Accessories List of Parts and AccessoriesReplacement Parts Description PART#Limited Warranty Guide d’utilisation, d’entretien et d’installation Page Table des matières Mise en garde de sécurité Lisez ET Conservez CES InstructionsFonctionnement Liste du matériel Installation Feuille de calcul pour le conduit d’aération Pièces de conduit Longueur Total Nombre utiliséHauteur de montage Conduit D’AÉRATIONInstallation Options pour le conduit d’aération Avertissement DE Risque D’INCENDIEInstallation Spécifications de la hotte Installation Installation de la hotte Installation Installation Installation de la hotte Installation Reprise d’air sans conduit Commandes Commandes à effleurement Commandes Indicateur de changement des filtres à charbon Page Commandes Commande à distance radioélectrique Des filtres et de la hotte Remplacement du filtre à tamisModèle de hotte No de pièce Quantité à Commander Entretien DES SurfacesRemplacement des ampoules Entretien LumièresEntretien Schéma de câblage Problème Cause Solution DépannageAccessoires optionnels Listes des pièces et des accessoiresPièces de remplacement Description No DE PièceGarantie limitée

ZGE-E36AS290, ZGE-E36AS, ZGE-E30AS290, ZGE-E30AS specifications

The Zephyr ZGE series, comprising models ZGE-E36AS, ZGE-E36AS290, ZGE-E30AS290, and ZGE-E30AS, represents a fusion of cutting-edge kitchen technology and sophisticated design, catering to culinary enthusiasts and home chefs alike.

The ZGE-E36AS is a standout model known for its powerful performance and sleek aesthetics. It features a robust ventilation system that effectively clears the air of smoke and odors while cooking. With a CFM rating of up to 800, it ensures that even the heaviest cooking sessions are met with efficient air circulation. The model includes LED lighting that illuminates the cooking surface, enhancing visibility during meal preparation.

The ZGE-E36AS290 takes this signature design a step further, equipped with advanced smart technology. This model supports Wi-Fi connectivity, allowing users to control the ventilation settings remotely via a dedicated app. It also features an intuitive touch control panel that simplifies operation and enables real-time monitoring and adjustments, making cooking easier and more efficient.

Moving on to the ZGE-E30AS290, this model is designed with versatility in mind. It boasts a compact form factor without sacrificing power. This range hood is ideal for kitchens with limited space, yet it provides an impressive 600 CFM extraction capability. Features such as a dishwasher-safe baffle filter and easy maintenance make the ZGE-E30AS290 a practical choice for any modern home.

Finally, the ZGE-E30AS is a classic solution that delivers reliability and performance. It incorporates a multi-speed fan system, allowing users to adjust the ventilation speed according to the cooking intensity. Its whisper-quiet operation ensures that ambient noise levels remain minimal, creating a serene cooking environment. Additionally, the model's stainless steel construction is not only aesthetically pleasing but also ensures durability and ease of cleaning.

Across all models, Zephyr emphasizes energy-efficient technology, promoting sustainability while enhancing kitchen functionality. The range is designed to blend seamlessly with various kitchen styles, from contemporary to traditional, ensuring they complement any interior design.

In summary, the Zephyr ZGE series is characterized by innovative technology, powerful ventilation, user-friendly features, and elegant designs. These models elevate the cooking experience, making them a valuable addition to any kitchen.