Frame Assembly, Trim Assembly | Vermont Casting IRHEDV32 specification

IMPORTANT: Only Trim Panel Assemblies approved by Vermont Castings Majestic Products Company can be used.

FRAME ASSEMBLY

1.Lay Trim Top Facing and Trim Side Facings, face down on to an even surface such as a table or floor. Be sure not to scratch the painted surfaces.

2.Install the nuts and bolts (Fig. 21).

10/24

SCREWS

FRAME TOP

AS SHOWN FROM BACK

Fig. 21

1.Install trim channels (left and right sides). Use two screws to assemble each piece.

2.Slide on the trim top channel and fasten it from the back side.

3.Install the trim top deflector and use two screws to fasten it. (Fig. 22 & 23)

4.Remove ALL plastic protective covering from brass trim.

Trim Top Deflector

Trim Frame Top Section

Side View

Fig. 24

1.Install trim channels (left and right sides). Use two screws to assemble each piece.

2.Peel off plastic protective covering from top edges of the inner sides where they will be covered by the inner top trim facing.

3.Place the trim facing inner top in place (do not fasten it yet). Peel off the plastic protective covering from the bottom edge.

4.Install the trim top deflector and fasten it (will hold the inner top piece). Use two screws to assemble them.

5.Install trim channels (left and right sides). Use two screws to assemble each piece.

6.Slide on the trim top channel and fasten it from the back side.

7.Remove ALL plastic protective covering from brass trim.

A flat louvre kit OR a bay window kit needs to be chosen to complete the installation.