General Glass Information

OPERATING INSTRUCTIONS

Only ceramic glass approved by Vermont Castings Majestic Products Company may be used for replacement on this unit.

1.The use of substitute glass will void all product warranties.

2.Care must be taken to avoid breakage of the glass.

3.Under no circumstances should this appliance be operated without glass properly installed, or with any cracked or broken glass. Replacement of any glass assembly as supplied by the manufacturer should be done by a licenced qualified service person.

LOUVRE REMOVAL

To remove louvre pull louvre up and then lift out.

1. Lift Up

2. Lift Out

Fig. 14

GLASS CLEANING

It will be necessary to clean the glass periodically. During start-up condensation, which is normal, forms on the inside of the glass and causes lint, dust and other airborne particles cling to the glass surface. Also initial paint curing may deposit a slight film on the glass. It is therefore recommended that the glass be cleaned two or three times with a non-ammonia household cleaner and warm water (we recommend gas fireplace glass cleaner). After that the glass should be cleaned two or three times during each heating season depending on the circumstances present.

Clean glass after first two weeks of operation.

GLASS FRAME REMOVAL

1.Remove four (4) bottom fastening nuts with a 3/8" nut driver. Fig. 15.

2.Lift up and unhook glass frame at the top.

	GLASS
	FRAME
10/24 NUT	10/24 NUT
	W
10/24 NUT	Fig. 15
10/24 NUT	Fig. 15
10003929

INSTALLATION OF LOGS & BURNER LAVA ROCK

1 . Remove front glass. (See "Glass Removal" section)

2.Remove logs from packaging.

3.Place rear log (KR4) on rear bracket (ensure log is seated properly, leveled and centered to the unit), so it will not move from side to side and it is firmly positioned on the bracket.

4.Slip front ember log (KR1) down in the front deflector.

5.Place front left log (KR2) on top burner, left side. Use log's bottom holes to locate it into the left bracket log locator studs.

6.Place front right log (KR3) on top of burner, right side. Use log's bottom holes to locate it into the right bracket log locator studs.

7.Place burner lava rocks material on top of burner. (See Fig. 16 for proper location).

8.Place top right log (KR6) onto locator notches. Ensure log is secure.

9.Place top left log (KR5) onto locator notches. Ensure log is secure.

Top logs must be placed properly into notches.

IRHEDV32

Fig. 18