Vermont Casting DVR33 manual EB-1 Electrical Box

Vermont Castings, Majestic Products: DVR33

EB-1 Electrical Box

The fireplace, when installed, must be electrically connected and grounded in accordance with local codes or, in the absence of local codes, with the current CSA C22.1 Canadian Electrical Code

For USA installations, follow the local codes and the national electrical code ANSI/NFPA No. 70.

It is strongly suggested that EB-1 Electrical Junction Box wiring be carried out by a licensed electrician.

Ensure that the power to the supply line has been disconnected before commencing this procedure.

The EB-1 electrical junction box has been supplied standard with this model to allow for easy installation of an optional fan kit.

To connect the EB-1 box to the house electrical supply follow the steps below.

1.Unscrew the retaining screw from the EB-1 base plate (Fig. 9), and remove the EB-1 assembly from the fireplace.

2.Remove the front cover of the EB-1 box.

3 Remove the plug socket assembly from the EB-1 box.

4.Feed the supply line in from the outside through the cable clamp (Fig. 9).

5.Connect black wire of the power supply line to the brass screw (polarized) of the socket assembly.

6.Connect the white wire of the power line to the chrome screw of the socket assembly.

7.Connect the ground wire of the supply line to the green screw of the socket assembly.

8.Refit the socket assembly back into the electrical box and replace the cover plate. Secure the cable with the clamp on the outside of the unit to prevent strain on the connections.

9.The EB-1 electrical junction box is now ready to supply power to the FK-12 or FK-24 fan kits, if so fitted.

	Inside
	Electrical Box
	Retaining Screw
	Front
	of Unit
	Outside
	of	Unit
	Front
		FP580
Fig. 9	EB-1 receptacle.

8 10004920