TC electronic SDN BHD manual Cloning P2’S, Cloning P2’s, Creating the Clone Card

Page 20

CLONING P2’S

Cloning P2’s

Creating the Clone Card

To easily clone multiple P2’s a PCMCIA card is used.

•Load appropriate presets into Front Panel Bank of the P2 you wish to clone.

•Insert a 512kb or 1Mb PCMCIA card in the Card slot on the P2 front panel.

•Go to the System Card page.

•Decide whether you wish to exclude System Preset 1 that holds overall Clock settings, Analog Trim levels, Dither, Status Bit settings and settings for GPI.

To exclude System Preset activate the “Exclude System Preset” key.

•Press the CREATE CLONE CARD key on the System/Card page.

•Please note following: ALL DATA

previously stored on the card will be destroyed when formatting the card.

•If the card is write-protected no data can be written on the card. The protect/un-protect- switch is located at the edge of the card.

Loading/Cloning P2 using the Clone Card. Once the clone card has been created on the P2 hooked up via the TC Icon PC Editor it is time to transfer the card data to other P2’s in your facility.

•Insert the PCMCIA card in the “target” P2.

•Press and hold the LOCK key while powering up the P2.

•Press the LOCK key again. In this mode the LOCK key operates as “CONFIRM”. BYPASS can be used to abort operation.

•The target P2 is now loaded with the information present on the card.

18

Image 20

Contents ADMINISTRATOR’S Manual Page Important Safety Instructions VoltageP2 Level Pilot For the customers in CanadaCertificate Of Conformity Table of Contents Concept FeaturesIntroduction Quick Start Daily UserFront Panel Overview Preset keys Wizard keyLock key Bypass keyRear Panel XLR to XLR XLR to Jack StereoSignal Flow Typical Setups Connecting and Setting up the P2Wizard Basics Front PanelLock Recall Four Bypass modes are available Front Panel OperationBypass Installing Problems?Requirements for running the TC Icon Software Editor CD-ROMTC Icon Editor IntroductionUnpacked and ready GenerallyLink Renaming presetsBasic Operation Preset Structure RECALL/STORE/DELETE System PresetsEngine Presets Library PagesBasics Preset Handling Bank HandlingCloning P2’S Cloning P2’sCreating the Clone Card Press the Create Clone Card key on the System/CardSystem I/O GPI Technical specifications ModeFront Panel Configuration System FrontCalibrate GPI Current voltageSystem NET page & Icon Views UI Icon ViewsAnalog In, Analog Out & Out Threshold Range 0 to 20dB Network identificationColor Main Analog vs. Digital level ConfigurationReference Level Loudness Processing ModesLevel Trim RatioAverage Rate Avg Rate Slow Window Range 0 to 20 dBParametric Filter Broad type IntroductionType Selector Gain Type Band Band Limiter Reset menu Software load LimiterappendixPort Conflict Appendix TroubleshootingLoading Preset Banks Appendix Technical Specifications Self Test Preset List SW Name Screen Notes Input Max Scale Design Notes DefaultMastering Name Screen Notes Input Max Scale Design Notes ReservedLive Mix Preset List SW