TC electronic SDN BHD P2 System Front, Calibrate, Front Panel Configuration, GPI Current voltage

Page 23

SYSTEM - FRONT PAGE

If GPI Preset mode is selected and no connections are made to the GPI Input

the P2 will always recall preset 1 at power up.

Delay

Frame compensation Delay. Actual Delay time can be tapped using a connected momentary switch.

Calibrate

Use this function to calibrate P2 to a connected GPI controller. E.g. TC Master Fader (not supplied).

To Calibrate:

•Connect GPI Controller to GPI Input and press CALIBRATE.

•Set GPI controller to Minimum position and press “Set Lo Threshold”.

•Set GPI controller to Max position and press “Set Hi Threshold”.

•Press OK and calibration is done.

GPI Current voltage:

Indicates the current voltage on the GPI Input. With no GPI controller connected the voltage is 1000 mV. Therefore it is worth noticing the max indicated value on e.g. Master Fader is a lower value in voltage compared to the min value.

Front Panel Configuration

On this page various preferences for the Front panel controls are set.

Wizard Mode

This parameter sets up the functionality of the front panel WIZARD key. The Wizard function examines part of the program material and automatically finds optimal compression settings based on the evaluation and the selected mode.

Via the TC Icon Editor the Administrator can both enable/disable the WIZARD function and also select between the three modes that determines the intensity of the compression.

Modes

Light

Mild compression is applied for preserved yet controlled dynamics. Only 1 to 2dB.

Normal

Medium compression is applied. 3-4 dB

Heavy

A harder compression for maximal control of dynamics. The compression is typically up to 6- 8dB. Consider whether the processing material will suffer from this type of compression.

Lock Mode

This parameter sets up the functionality of the front panel LOCK key. Thereby the editing options for the everyday user can be limited to different degrees.

Press the round LOCK key to activate the Lock function.

21

Page 22 Page 24
Image 23
Page 22 Page 24
Contents ADMINISTRATOR’S Manual Page Voltage Important Safety InstructionsP2 Level Pilot For the customers in CanadaCertificate Of Conformity Table of Contents Concept FeaturesIntroduction Daily User Quick StartFront Panel Overview Bypass key Preset keysWizard key Lock keyXLR to XLR XLR to Jack Stereo Rear PanelSignal Flow Connecting and Setting up the P2 Typical SetupsWizard Basics Front PanelLock Recall Four Bypass modes are available Front Panel OperationBypass CD-ROM InstallingProblems? Requirements for running the TC Icon Software EditorGenerally TC Icon EditorIntroduction Unpacked and readyLink Renaming presetsBasic Operation Library Pages Preset Structure RECALL/STORE/DELETESystem Presets Engine PresetsBank Handling Basics Preset HandlingPress the Create Clone Card key on the System/Card Cloning P2’SCloning P2’s Creating the Clone CardSystem I/O Mode GPI Technical specificationsGPI Current voltage Front Panel ConfigurationSystem Front CalibrateNetwork identification System NET page & Icon ViewsUI Icon Views Analog In, Analog Out & Out Threshold Range 0 to 20dBColor Main Analog vs. Digital level ConfigurationReference Level Processing Modes LoudnessSlow Window Range 0 to 20 dB Level TrimRatio Average Rate Avg RateParametric Filter Broad type IntroductionType Selector Gain Type Band Band Limiter Limiterappendix Reset menu Software loadPort Conflict Appendix TroubleshootingLoading Preset Banks Appendix Technical Specifications Self Test Name Screen Notes Input Max Scale Design Notes Default Preset List SWMastering Name Screen Notes Input Max Scale Design Notes ReservedLive Mix Preset List SW
Top Page Image Contents