TC electronic SDN BHD P2 manual Front Panel Overview

Page 8

FRONT PANEL OVERVIEW

POWER On/Off Switches power On/Off.

To completely disconnect from mains the Rear panel POWER switch must be used.

PCMCIA slot

For software updates and preset backups.

ERROR LED

Indicates various error states.

48/44.1/32 kHz LEDs Indicates current Sample Rate.

ANALOG IN/DIGITAL IN Indicates currently selected Input type.

DUAL MONO LED Indicates that the P2 is operating in Dual mono mode.

EDITED LED

Indicates that the currently recalled preset has been edited but not stored.

This LED will also be lit when the Wizard has

been activated.

GAIN meter

Indicates the max gain applied on either channels. The indication is “wideband” type.

OPTIMIZE meters

Indicates the gain optimization on each of the 5 bands.

LIMIT meter

Indicates the max limitation performed on either channels.

INPUT/OUTPUT meters

The Input meters indicate the level of the Input signal after the In Gain control. (set via the TC Icon control interface).

The Output meters indicate the current Output level.

Threshold value for meter color change:

For both Input/Output meters: Below -20dB the meter LEDs are green. From -20dB to 0dB LED color can be green or yellow.

The value for this color change is set via the TC Icon Editor on the System Front page.

6

Image 8
Contents ADMINISTRATOR’S Manual Page Important Safety Instructions VoltageP2 Level Pilot For the customers in CanadaCertificate Of Conformity Table of Contents Concept FeaturesIntroduction Quick Start Daily UserFront Panel Overview Preset keys Wizard keyLock key Bypass keyRear Panel XLR to XLR XLR to Jack StereoSignal Flow Typical Setups Connecting and Setting up the P2Wizard Basics Front PanelLock Recall Four Bypass modes are available Front Panel OperationBypass Installing Problems?Requirements for running the TC Icon Software Editor CD-ROMTC Icon Editor IntroductionUnpacked and ready GenerallyLink Renaming presetsBasic Operation Preset Structure RECALL/STORE/DELETE System PresetsEngine Presets Library PagesBasics Preset Handling Bank HandlingCloning P2’S Cloning P2’sCreating the Clone Card Press the Create Clone Card key on the System/CardSystem I/O GPI Technical specifications ModeFront Panel Configuration System FrontCalibrate GPI Current voltageSystem NET page & Icon Views UI Icon ViewsAnalog In, Analog Out & Out Threshold Range 0 to 20dB Network identificationColor Main Analog vs. Digital level ConfigurationReference Level Loudness Processing ModesLevel Trim RatioAverage Rate Avg Rate Slow Window Range 0 to 20 dBParametric Filter Broad type IntroductionType Selector Gain Type Band Band Limiter Reset menu Software load LimiterappendixPort Conflict Appendix TroubleshootingLoading Preset Banks Appendix Technical Specifications Self Test Preset List SW Name Screen Notes Input Max Scale Design Notes DefaultMastering Name Screen Notes Input Max Scale Design Notes ReservedLive Mix Preset List SW