Empire Comfort Systems pmn manual Assembly of Stove Casting

Page 10

ASSEMBLY OF STOVE CASTING

Figure 6

5.Align the 3/8" hole at the top of the leg with the 3/8" hole in the leg pad. Attention: For proper positioning of the leg to the leg pad the (2) 1-1/2" top edges of the leg must be placed flush and parallel to the (2) edges on the leg pad. Attach leg to leg pad by inserting (1) 1" bolt through the leg pad and into the leg, secure bolt with 1/4" nut.

6.Insert (2) 3/8" bolts into the (2) holes on the edges of the casting sides. The bolts should only be threaded half-way into the holes in order to allow for clearance when the casting back is attached to the casting sides.

7.Refer to Figure 7, the rear cover has (4) keyholes for attachment to the casting sides. Stand the casting sides on the floor with the (2) bolts attached half-way into the edges of the rear cover positioned at the rear. The large diameter holes in the keyholes of the rear cover will be toward the floor. Working with one casting side at a time, place the large diameter holes in the keyholes over and behind both of the bolts at the same time. Push downward on the rear cover to lock the keyholes into position behind the bolts. Finish tightening both bolts to secure rear cover to casting side. Repeat this procedure to secure rear cover to the second casting side.

Figure 7

Page 10

15627-4-0806

Image 10
Contents Installation Instructions Table of Contents Important Safety Information This is a Heating ApplianceSafety Information for Users of LP-GAS LP-GAS Warning OdorIntroduction Specifications CIBV-30Recommended Gas Pipe Diameter Installing a New Main Gas CockGAS Supply Checking Manifold PressureInstallation on Rugs and Tile ClearancesAppliance Hardware Package Assembly of Stove CastingDetailed Instructions Follow Assembly of Stove Casting 15627-4-0806 Installation of Optional Stone Inlay Optional Stone Inlay InstallationParts List Wire Channel Installation LOG PlacementVent Safety Shutoff System Operating GuidelinesLiner and Insulated Liner VentingVenting Insulated Vent Enclosure FigureFor Your Safety Read Before Lighting Lighting InstructionsAir Shutter Adjustment Pilot Flame CharacteristicsMain Burner Flame Characteristics Cleaning the Log Set and FireboxWiring Maintenance & Service Instructions MaintenanceCleaning Procedure Glass Assembly Replacement Glass CleaningGeneral Glass Information Pilot and main burner extinguish while in operation TroubleshootingFrequent pilot outage problem Glass sootsHOW to Order Repair Parts Parts List for CIBV-30-20Parts View for CIBV-30-20 Parts List for Stove Casting Parts View for Stove Casting Refer to Wire Channel Installation, Optional Blower Installation InstructionsInstalling Optional CIB-2 Blower Fan ControlBlower Motor CleaningWiring Index Part No. No. DescriptionFAX