3M manual Introduction, Initial Set-up, Dynatel 1420EZ Stand Assembly

Introduction

The Dynatel™ 1420EZ Station consists of the following items;

1.Dynatel™ 1420EZ Stand: Writing stand that can hold up to ten Ball or ten Near Surface or ten Disk iD-Markers in pre- allocated slots.

2.Dynatel™ 1420EZ Writer: iD-Marker reading and writing unit

3.Dynatel™ PCTools: Software program that works with the 1420EZ Writer to provide an easy solution for writing up to ten iD-Markers (of the same type/frequency) at one time utilizing user data templates which are created using a PC, and the Dynatel™ PCTools software program.

Initial Set-up

Dynatel™ 1420EZ Stand Assembly

NOTE: Dynatel™ 1420EZ Stand Assembly Instructions are also included in the shipping box.

The Dynatel™ 1420EZ Stand consists of six (6) components (identified in illustration below);

a.One (1) Upper level iD-Marker holding tray

b.One (1) Lower level iD-Marker holding tray

c.One (1) Stand stability holding tray

d.Three (3) Stand legs

Assembly of components

1.Slide “Item C” slot into the lower slot of one (1) “Item D” component.

Note: the lower slot in the “Item D” component is farther from the end of “Item D” than the upper slot. (See illustration.)

2.Slide “Item B” slot into the middle slot, and “Item A” slot into the top slot, of the “Item D” component.

Note: It is imperative that the color dot labels on the top surfaces of “Item C”, “Item B” and “Item A” line up.

3.Slide the second (2nd) and third (3rd) “Item D” components into the appropriate slots on “Item A”, “Item B” and “Item C”.

mCaution

To reduce the risks associated with falling/impact due to Stand Assembly break down:

•DO NOT sit on, or over load, the Stand Assembly.

4 78-9000-0120-3-A