Removing the oven door and the glass panel
1 Open the door fully | 2 Lift and turn the levers |
and hold the two door | on the two hinges. |
hinges. |
|
1
1 |
3 |
| 6 | Lift the inner door. | |
2 | 7 | Clean inner side of the | ||
2 | door. | |||
| ||||
Clean the glass panel with water and soap. Dry it carefully.
5Use a spatula made of wood or plastic or equiva- lent to open the inner door.
Hold the outer door, and push the inner door against the top edge of the door.
Warning! Only clean the glass panel with water and a soap. Abrasive cleaning agents, stain removers
and sharp objects (e.g. knives or scrapers) can cause damage to the glass.
3Close the oven door to the first opening position (halfway). Then pull for- ward and remove it from its seat.
4 Place the door on a |
stable surface protected by |
a soft cloth. |
Use a screwdriver to re- |
move 2 screws from the |
Inserting the door and the glass panel
When the cleaning procedure is completed, insert the oven door. To do so, do the steps in opposite way.
bottom edge of the door. |
4
4
Important! Do not lose the screws.
.
6
5
5
What to do if…
Problem
The flame is blown out immediately after ignition.
The gas ring burns unevenly.
The oven does not heat up.
Possible cause
The thermocouple is not heated suffi- ciently.
The burner crown is blocked with food residue.
The oven is not activated.
Remedy
After lightning the flame, keep the knob pushed for approximately 10 seconds.
Make sure that the injector is not blocked and the burner crown is clear of food particles.
Activate the appliance.
www.zanussi.com
11